900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




NXP Semiconductors Electronic Components Datasheet

NHS3100 Datasheet

Temperature logger

No Preview Available !

NHS3100
Temperature logger
Rev. 6.03 — 15 June 2018
Product data sheet
1 General description
The NHS3100 is an IC optimized for temperature monitoring and logging. It has
an embedded NFC interface, an internal temperature sensor and a direct battery
connection. These features support an effective system solution with a minimal number
of external components and a single layer foil implementation for temperature monitoring.
The NHS3100 works either battery-powered or NFC-powered.
The embedded ARM Cortex-M0+ offers flexibility to the users of this IC to implement
their own dedicated solution. The NHS3100 contains multiple features, including multiple
Power-down modes and a selectable CPU frequency of up to 8 MHz, for ultra low power
consumption.
Users can program this NHS3100 with the industry-wide standard solutions for ARM
Cortex-M0+ processors.
As of September 22, 2017, this device has been certified by the NFC forum (certification
ID: 58516).
CAUTION
Semiconductors are light sensitive. Exposure to light sources can cause the IC to
malfunction. The IC must be protected against light. The protection must be applied to all
sides of the IC.
CAUTION
msc896
This device is sensitive to ElectroStatic Discharge (ESD). Observe precautions for handling
electrostatic sensitive devices.
Such precautions are described in the ANSI/ESD S20.20, IEC/ST 61340-5, JESD625-A or
equivalent standards.


NXP Semiconductors Electronic Components Datasheet

NHS3100 Datasheet

Temperature logger

No Preview Available !

NXP Semiconductors
NHS3100
Temperature logger
2 Features and benefits
2.1 System
ARM Cortex-M0+ processor running at frequencies of up to 8 MHz
ARM Cortex-M0+ built-in Nested Vectored Interrupt Controller (NVIC)
ARM Serial Wire Debug (SWD)
System tick timer
IC reset input
2.2 Memory
32 kB on-chip flash programming memory
4 kB on-chip EEPROM of which 320 bytes are write-protected
8 kB SRAM
2.3 Digital peripherals
Up to 12 General Purpose Input Output (GPIO) pins with configurable pull-up/pull-down
resistors and repeater mode
GPIO pins which can be used as edge and level sensitive interrupt sources
High-current drivers (sink only; 20 mA) on four GPIO pins
High-current drivers (sink only; 20 mA) on two I2C-bus pins
Programmable WatchDog Timer (WDT)
2.4 Analog peripherals
Temperature sensor with ±0.3 °C absolute temperature accuracy between 0 °C and
40 °C and ±0.5 °C in the range −40 °C and +85 °C
2.5 Communication interfaces
NFC/RFID ISO 14443 type A interface; NFC forum type 2 compatible
I2C-bus interface supporting full I2C-bus specification and Fast-mode with a data rate of
400 kbit/s, with multiple-address recognitions and Monitor mode
2.6 Clock generation
8 MHz internal RC oscillator, trimmed to 2 % accuracy, which is used for the system
clock
Timer oscillator operating at 32 kHz linked to the RTC timer unit
NHS3100
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 6.03 — 15 June 2018
© NXP B.V. 2018. All rights reserved.
2 / 45


Part Number NHS3100
Description Temperature logger
Maker NXP
Total Page 3 Pages
PDF Download

NHS3100 Datasheet PDF

View PDF for Mobile






Similar Datasheet

1 NHS3100 Temperature logger
NXP





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy