Datasheet4U Logo Datasheet4U.com

LM2747 - Synchronous Buck Controller

Description

The LM2747 is a high-speed synchronous buck regulator controller with a feedback voltage accuracy of ± 1%.

It can provide simple down conversion to output voltages as low as 0.6V.

Features

  • a fixed-frequency voltage-mode PWM control architecture which is adjustable from 50 kHz to 1 MHz with one external resistor. In addition, the LM2747 also allows the switching frequency to be synchronized to an external clock signal over the range of 250 kHz to 1 MHz. This wide range of switching frequency gives the power supply designer the flexibility to make better tradeoffs between component size, cost and efficiency. Features include the ability to startup with a pre-biased load on the outpu.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LM2747 Synchronous Buck Controller Texas Instruments
LM27402 High-Performance Synchronous Buck Controller Texas Instruments
LM27403 Synchronous Buck Controller Texas Instruments
LM2742 N-Channel FET Synchronous Buck Regulator Controller Texas Instruments
LM2743 synchronous buck controller Texas Instruments

Other Datasheets by National Semiconductor (Texas Instruments)

Part Number Description
LM2742 N-Channel FET Synchronous Buck Regulator Controller
LM2743 N-Channel FET Synchronous Buck Regulator Controller
LM2744 Low Voltage N-Channel MOSFET Synchronous Buck Regulator Controller
LM2745 (LM2745 / LM2748) Synchronous Buck Controller
LM2746 Low Voltage N-Channel MOSFET Synchronous Buck Regulator Controller

Full PDF Text Transcription

Click to expand full text
www.DataSheet4U.com LM2747 Synchronous Buck Controller with Pre-bias Startup, and Optional Clock Synchronization March 2006 LM2747 Synchronous Buck Controller with Pre-bias Startup, and Optional Clock Synchronization General Description The LM2747 is a high-speed synchronous buck regulator controller with a feedback voltage accuracy of ± 1%. It can provide simple down conversion to output voltages as low as 0.6V. Though the control section of the IC is rated for 3 to 6V, the driver section is designed to accept input supply rails as high as 14V. The use of adaptive non-overlapping MOSFET gate drivers helps avoid potential shoot-through problems while maintaining high efficiency.
Published: |