Datasheet4U Logo Datasheet4U.com

LM48510 - boosted class D audio power amplifier

Description

The LM48510 integrates a boost converter with a high efficiency mono, Class D audio power amplifier to provide 1.2W continuous power into an 8Ω speaker when operating on a 3.3V power supply with boost voltage (PV1) of 5.0V.

Features

  • a low-power consumption shutdown mode. Shutdown may be enabled by driving the Shutdown pin to a logic low (GND). The gain of the Class D is externally configurable which allows independent gain control from multiple sources by summing the signals. Output short circuit and Thermal shutdown protection prevent the device from damage during fault conditions. Superior click and pop suppression eliminates audible transients during power-up and shutdown. Key Specifications.
  •  Quiescent Power Supply.

📥 Download Datasheet

📁 Similar Datasheet

  • LM48511 - Audio Power Amplifier (Texas Instruments)
  • LM48512 - Audio Power Amplifier (Texas Instruments)
  • LM48520 - Audio Power Amplifier (Texas Instruments)
  • LM4853 - Power Amplifier (Texas Instruments)
  • LM4855 - Integrated Audio Amplifier (Texas Instruments)
  • LM48556 - Ceramic Speaker Driver (Texas Instruments)
  • LM48557 - Ceramic Speaker Driver (Texas Instruments)
  • LM48560 - Ceramic Speaker Driver (Texas Instruments)
  • LM4857 - Stereo 1.2W Audio Sub-system (Texas Instruments)
  • LM48580 - Haptic Piezo Actuator / Ceramic Speaker Driver (Texas Instruments)
Other Datasheets by National Semiconductor
  • LM4851 - Integrated Audio Amplifier
  • LM48511 - Class D Audio Power Amplifier
  • LM4850 - Mono 1.5W / Stereo 300mW Power Amplifier
  • LM4852 - Integrated Audio Amplifier
  • LM48520 - Boosted Stereo Class D Audio Power Amplifier
  • LM4853 - Mono 1.5W / Stereo 300mW Power Amplifier
  • LM4854 - 1.9W Monaural / 85mW Stereo Headphone Audio Amplifier
  • LM4855 - Boomer AUDIO POWER AMPLIFIER

Full PDF Text Transcription

Click to expand full text
www.DataSheet4U.com LM48510 Boosted Class D Audio Power Amplifier November 2006 LM48510 Boosted Class D Audio Power Amplifier General Description The LM48510 integrates a boost converter with a high efficiency mono, Class D audio power amplifier to provide 1.2W continuous power into an 8Ω speaker when operating on a 3.3V power supply with boost voltage (PV1) of 5.0V. When operating on a 3.3V power supply, the LM48510 is capable of driving a 4Ω speaker load at a continuous average output of 1.7W with less than 1% THD+N. The Class D amplifier is a low noise, filterless PWM architecture that eliminates the output filter, reducing external component count, board area consumption, system cost, and simplifying design.
Published: |