LMC6036 Datasheet | National Semiconductor

LMC6035/LMC6036 Low Power 2.7V Single Supply CMOS Operational Amplifiers January 2000 LMC6035/LMC6036 Low Power 2.7V Single Supply CMOS Operational Amplifiers General Description The LMC6035/6 is an economical, low voltage op amp capable of rail-to-rail output swing into loads of 600Ω. LMC6035 is available in a chip sized package (8-Bump micro SMD) using National’s micro SMD package technology. Both allow for single supply operation and are guaranteed for 2.7V, 3V, 5V and 15V supply voltage. The 2.7 supply voltage corresponds to the End-of-Life voltage (0.9V/cell) for three Ni Cd or Ni MH batteries in series, making the LMC6035/6 well suited for portable and rechargeable systems. It also Features a well behaved decrease in its specifications at supply voltages below its guaranteed 2.7V operation. This provides a “fort zone” for adequate operation at voltages significantly below 2.7V. Its ultra low input currents (IIN) makes it well suited for low power active filter application, because it allows the use of higher resistor values and lower capacitor values. In addition, the drive capability of the LMC6035/6 gives these op amps a broad range of applications for low voltage systems. Features (Typical Unless Otherwise Noted) n LMC6035 in micro SMD Package n Guaranteed 2.7V, 3V, 5V and 15V Performance n Specified for 2 kΩ and 600Ω Loads n Wide Operating Range: 2.0V to 15.5V n Ultra Low Input Current: 20 f A n Rail-to-Rail Output Swing @ 600Ω: 200 m V from either rail at 2.7V @ 100 kΩ: 5 m V from either rail at 2.7V n High Voltage Gain: 126d B n Wide Input mon-Mode Voltage Range -0.1V to 2.3V at Vs = 2.7V n Low Distortion: 0.01% at 10 k Hz Applications n n n n Filters High Impedance Buffer or Preamplifier Battery Powered Electronics Medical Instrumentation Connection Diagrams 8-Pin SO/MSOP 8-Bump micro SMD DS012830-1 Top View 14-Pin SO/TSSOP Top View (Bump Side Down) DS012830-65 DS012830-2 Top View © 2000 National Semiconductor Corporation DS012830 .nation...