ALUMINUM ELECTROLYTIC CAPACITORS
GG Snap-in Terminal Type, 105°C Ultra-Smaller-Sized
series
One rank smaller case sized than GN series.
Suited for equipment down sizing.
Compliant to the RoHS directive (2002/95/EC).
GN
Smaller
GG
Smaller
Specifications
GL
Item
Performance Characteristics
Category Temperature Range
– 40 to +105°C (160 to 250V) , – 25 to +105°C (400 to 450V)
Rated Voltage Range
160 to 450V
Rated Capacitance Range
100 to 3300µF
Capacitance Tolerance
± 20% at 120Hz, 20°C
Leakage Current
I 3 CV(µA) (After 5 minutes' application of rated voltage) [C : Rated Capacitance (µF) V : Voltage (V)]
Tangent of loss angle (tan δ) Rated voltage (V)
tan δ (MAX.)
160 to 420
0.15
450
0.20
Measurement frequency : 120Hz, Temperature : 20°C
Stability at Low Temperature
Rated voltage (V)
Impedance ratio
ZT/Z20 (MAX.)
Z – 25°C/ Z+20°C
160 to 250
4
400 to 450
8
Measurement frequency : 120Hz
Temperature : 20°C
Endurance
Shelf Life
Marking
The specifications listed at right shall be met when the
capacitors are restored to 20°C after D.C. bias plus
rated ripple current is applied for 2000 hours at 105°C,
the peak voltage shall not exceed the rated voltage.
After storing the capacitors under no load at 105°C for 1000
hours and then performing voltage treatment based
on JIS C 5101-4 clause 4.1 at 20°C,
they shall meet the characteristic requirements listed at right.
Printed with white color letter on black sleeve.
Capacitance change
tan δ
Leakage current
Within ± 20% of the initial capacitance value
200% or less than the initial specified value
Less than or equal to the initial specified value
Capacitance change
tan δ
Leakage current
Within ± 20% of the initial capacitance value
200% or less than the initial specified value
Less than or equal to the initial specified value
Drawing
Polarity bar
Sleeve (P.E.T.)
L± 2
Pressure relief vent
4.0± 0.5
10 ± 0.1
10
0.8
+0.2
-0.1
0.8+-00..21
2-2φ ± 0.1
(PC board hole dimensions)
1.5
+0.2
-0.1
(Terminal dimensions)
The other terminal is also available upon request.
Please refer page 272 for schematic of dimensions.
Type numbering system (Example : 400V 180µF)
1 2 3 4 5 6 7 8 9 10 11 12 13 14
L GG 2 G 1 8 1 M EL A 2 5
Configuration
Capacitance tolerance (± 20%)
Rated capacitance (180µF)
Rated voltage (400V)
Series name
Type
Case length code
Case dia. code
φD Code
22 Z
25 A
30 B
35 C
Minimum order quantity : 50pcs.
Dimension table in next page.
CAT.8100Z
