Datasheet4U Logo Datasheet4U.com

AMIS-30522 - Micro-Stepping Motor Driver

Description

.

4 Equivalent Schematics

.

.

.

5 Thermal Resist

Features

  • Dual H.
  • Bridge for 2 Phase Stepper Motors.
  • Programmable Peak.
  • Current up to 1.2 A Continuous (1.5 A Short Time), Using a 5.
  • Bit Current DAC.
  • On.
  • Chip Current Translator.
  • SPI Interface.
  • Speed and Load.
  • Angle Output.
  • 7 Step Modes from Full.
  • Step up to 32 Micro.
  • Steps.
  • Fully Integrated Current.
  • Sense.
  • PWM Current Control with Automatic Selection of Fast and Slow Decay.

📥 Download Datasheet

Datasheet preview – AMIS-30522

Datasheet Details

Part number AMIS-30522
Manufacturer ON Semiconductor
File Size 336.10 KB
Description Micro-Stepping Motor Driver
Datasheet download datasheet AMIS-30522 Datasheet
Additional preview pages of the AMIS-30522 datasheet.

📁 Similar Datasheet

  • AMIS-30522 - Micro-stepping Motor Driver (AMI SEMICONDUCTOR)
  • AMIS-30521 - Micro-stepping Motor Driver (AMI SEMICONDUCTOR)
  • AMIS-30585 - S-FSK PLC Modem (AMI SEMICONDUCTOR)
  • AMIS-30600 - LIN Transceiver (AMI SEMICONDUCTOR)
  • AMIS-30621 - LIN Microstepping Motordriver (AMI SEMICONDUCTOR)
  • AMIS-30660 - High Speed CAN Transceiver (AMI SEMICONDUCTOR)
  • AMIS-30663 - High Speed CAN Transceiver (AMI SEMICONDUCTOR)
  • AMIS-39100 - Octal High Side Driver (AMI SEMICONDUCTOR)
  • AMIS-39101 - Octal High-Side Driver (AMI SEMICONDUCTOR)
  • AMIS-14935 - Audio Amplifier (AMIS)
Other Datasheets by ON Semiconductor

Full PDF Text Transcription

Click to expand full text
AMIS-30522, NCV70522 Micro-Stepping Motor Driver Introduction The AMIS−30522/NCV70522 is a micro−stepping stepper motor driver for bipolar stepper motors. The chip is connected through I/O pins and a SPI interface with an external microcontroller. The AMIS−30522/NCV70522 contains a current−translation table. It takes the next micro−step depending on the clock signal on the “NXT” input pin and the status of the “DIR” (= direction) register or input pin. The chip provides a so−called “Speed and Load Angle” output. This allows the creation of stall detection algorithms and control loops based on load−angle to adjust torque and speed. It is using a proprietary PWM algorithm for reliable current control.
Published: |