FL7930C Datasheet | onsemi

Features ! PFC-Ready Signal ! VIN-Absent Detection ! Maximum Switching Frequency Limitation ! Internal Soft-Start and Startup without Overshoot ! Internal Total Harmonic Distortion (THD) Optimizer ! Precise Adjustable Output Over-Voltage Protection ! Open-Feedback Protection and Disable Function ! Zero-Current Detector (ZCD) ! 150 µs Internal Startup Timer ! MOSFET Over-Current Protection (OCP) ! Under-Voltage Lockout with 3.5 V Hysteresis ! Low Startup and Operating Current ! Totem-Pole Output with High State Clamp ! +500/-800 m A Peak Gate Drive Current ! 8-Pin, Small Outline Package (SOP) Applications ! Ballast ! General LED Lighting ! Industrial, mercial, and Residential Fixtures ! Outdoor Lighting: Street, Roadway, Parking, Construction, Ornamental LED Lighting Fixtures Description The FL7930C is an active power factor correction (PFC) controller for boost PFC applications that operate in critical conduction mode (CRM). It uses a voltage-mode PWM that pares an internal ramp signal with the error amplifier output to generate a MOSFET turn-off signal. Because the voltage-mode CRM PFC controller does not need rectified AC line voltage information, it saves the power loss of an input voltage-sensing network necessary for a current-mode CRM PFC controller. FL7930C provides over-voltage protection (OVP), openfeedback protection, over-current protection (OCP), input-voltage-absent detection, and under-voltage lockout protection (UVLO). The PFC-ready pin can be used to trigger other power stages when PFC output voltage reaches the proper level with hysteresis. The FL7930C can be disabled if the INV pin voltage is lower than 0.45 V and the operating current decreases to a very low level. Using a new variable on-time control method, total harmonic distortion (THD) is lower than in conventional CRM boost PFC ICs. Ordering Information Part Number Operating Temperature Range Top Mark Package Packing Method FL7930CMX-G -40 to +125°C FL7930CG 8-Lead, Small Outline...