Datasheet4U Logo Datasheet4U.com

NBC12430 - Programmable PLL Synthesized Clock Generator

Description

of the functionality of the NBC12430 and NBC12430A Inputs and Outputs.

explicitly stated, all inputs are CMOS/TTL compatible with either pullup or pulldown resistors.

The PECL outputs are capable of driving two series terminated 50 W transmission lines on the incident edge.

Features

  • Best.
  • in.
  • Class Output Jitter Performance, ±20 ps Peak.
  • to.
  • Peak.
  • 50 MHz to 800 MHz Programmable Differential PECL Outputs.
  • Fully Integrated Phase.
  • Lock.
  • Loop with Internal Loop Filter.
  • Parallel Interface for Programming Counter and Output Dividers During Powerup.
  • Minimal Frequency Overshoot.
  • Serial 3.
  • Wire Programming Interface.
  • Crystal Oscillator Interface.
  • Operating Range:.

📥 Download Datasheet

Datasheet Details

Part number NBC12430
Manufacturer onsemi
File Size 344.39 KB
Description Programmable PLL Synthesized Clock Generator
Datasheet download datasheet NBC12430 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
NBCW011T WHITE LED NICHIA

Other Datasheets by onsemi

Part Number Description
NBC12430A Programmable PLL Synthesized Clock Generator
NBC12439 Programmable PLL Synthesized Clock Generator
NBC12439A Programmable PLL Synthesized Clock Generator
NBC12429 Programmable PLL Synthesized Clock Generator
NBC12429A Programmable PLL Synthesized Clock Generator

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
3.3 V/5 V Programmable PLL Synthesized Clock Generator 50 MHz to 800 MHz NBC12430, NBC12430A The NBC12430 and NBC12430A are general purpose, PLL based synthesized clock sources. The VCO will operate over a frequency range of 400 MHz to 800 MHz. The VCO frequency is sent to the N−output divider, where it can be configured to provide division ratios of 1, 2, 4, or 8. The VCO and output frequency can be programmed using the parallel or serial interfaces to the configuration logic. Output frequency steps of 250 kHz, 500 kHz, 1.0 MHz, 2.0 MHz can be achieved using a 16 MHz crystal, depending on the output dividers settings. The PLL loop filter is fully integrated and does not require any external components.
Published: |