NCP81611
NCP81611 is 4/3/2/1 Multi-Phase Buck Controller manufactured by onsemi.
Description
The NCP81611 is a multiphase synchronous controller optimized for new generation puting and graphics processors. The device is capable of driving up to 4 phases and incorporates differential voltage and phase current sensing, adaptive voltage positioning and PWM_VID interface to provide and accurately regulated power for puter or graphic controllers. The integrated power saving interface (PSI) allows for the processors to set the controller in one of three modes, i.e. all phases on, dynamic phases shedding or fixed low phase count mode, to obtain high efficiency in light- load conditions. The dual edge PWM multiphase architecture ensures fast transient response and good dynamic current balance.
Features
- pliant with NVIDIA OVR4i+ Specifications
- Supports up to 4 Phases
- 2.8 V to 20 V Supply Voltage Range:
- 250 k Hz to 1.2 MHz Switching Frequency (4 Phase)
- Power Good Output
- Under Voltage Protection (UVP)
- Over Voltage Protection (OVP)
- System Over Current Protection (OCP)
- Per Phase Over Current Limiting (OCL)
- Startup into Pre- Charged Loads while Avoiding False OVP
- Configurable Load Line
- High Performance Operational Error Amplifier
- True Differential Current Balancing Sense Amplifiers for Each Phase
- Phase- to- Phase Dynamic Current Balancing
- Current Mode Dual Edge Modulation for Fast Initial Response to
Transient Loading
- Power Saving Interface (PSI)
- Automatic Phase Shedding with User Settable Thresholds
- PWM_VID and I2C Control Interface
- pact 40 Pin QFN Package (5 x 5 mm Body, 0.4 mm Pitch)
- These Devices are Pb- Free and are Ro HS pliant
Typical Applications
- GPU and CPU Power
- Graphic Cards
- Desktop and Notebook Applications
- Docking Stations
- Power Banks
.onsemi.
1 40 QFN40 5x5, 0.4P
CASE 485CR
MARKING DIAGRAM 1
NCP81611 AWLYYWW
NCP81611 = Device Code
= Assembly Site
= Wafer Lot...
