T-51750-SERIES APPLICATION NOTE
(a) T-51750GD065J-FW-AA LCD Module Technical Specification First Edition 4 December 2003.
(b) T-51750GD065J-FW-AB LCD Module Technical Specification First Edition 24 October 2003.
(c) T-51750AA Series Drawing UE-311848A dated 31 October 2003
1.1. This application note provides information for transitioning from the T-51382-series 6.4-inch thin
film transistor (TFT) display to the T-51750-series 6.5-inch display. This document identifies
performance and specification differences as well as instructions for direct replacement.
2. T-51750 ERRATA SPECIFICATIONS
2.1. Section 1 of reference (a) identifies the LCD type as normally-white mode / transflective which is
not correct. The display is normally-white mode / transmissive.
3. T-51750-SERIES & T-51382-SERIES GENERAL DIFFERENCES
3.1. Table 1 identifies major characteristics of the T-51750 and T-51382 display families. The T-
51750-series are smaller, more power efficient, and higher performing display over the series it
Table 1 -- T-51750-Series & T-51382-Series Characteristics
-AA & -AB
0° - 60° C
-25° - 70° C
132.5 x 99.4
0° - 55° C
-25° - 70° C
-20° - 70° C
-30° - 70° C
0.675 x 3[RGB] x 0.203 mm
129.6 x 97.4 mm
175.0 x 126.5 x 12.0 mm
AG on -AA
AR on -AB
T-51750 larger pixel increases
aperture ratio which improves color
T-51750 has 4% larger area.
15% length reduction
4.5% width reduction
4% height reduction
43% reduction in weight.
AG – anti-glare coating for reduced
reflections (matte surface)
AR – anti-reflective coating to reduce
glare (caused by index of
refraction differences) and
improve sunlight readability (AR
coating is a specular surface)
Symmetric display and reverse scan
capability allow selection of best
viewing direction (6:00 or 12:00)
by rotating display and reversing
Page 2 of 10
datasheet pdf -