UF1006F Datasheet | PanJit Semiconductor

UF1000F THRU UF1008F ULTRAFAST SWITCHING RECTIFIER VOLTAGE - 50 to 800 Volts CURRENT - 10.0 Amperes Features l Plastic package has Underwriters Laboratory Flammability Classification 94V-O Utilizing l l l l l Flame Retardant Epoxy Molding pound Exceeds environmental standards of MIL-S-19500/228 Low power loss, high efficiency Low forward voltage, high current capability High surge capacity Ultra Fast recovery times, high voltage ITO-220AC MECHANICAL DATA Case: ITO-220AC full molded plastic package Terminals: Lead solderable per MIL-STD-202, Method 208 Polarity: As marked Mounting Position: Any Weight: 0.08 ounce, 2.24 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ¢J ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20% TYPE NUMBER Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current .375”(9.5mm) lead length @ TC=100 ¢J Peak Forward Surge Current, 8.3ms single half sine wave superimposed on rated load(JECEC method) Maximum Instantaneous Forward Voltage at 10.0A Maximum DC Reverse Current @TA=25 ¢J at Rated DC Blocking Voltage @TA=125 ¢J Maximum Reverse Recovery Time(Note 1) Typical Junction capacitance (Note 2) Typical Junction Resistance (Note 2) R £K JA Operating and Storage Temperature Range TJ,TSTG UF1000F UF1001F UF1002F UF1003F UF1004F UF1006F UF1008F UNITS 50 35 50 100 70 100 200 140 200 300 210 300 10.0 150 400 280 400 600 420 600 800 560 800 V V V A A 1.0 10.0 500 50 80 V £g A £g A ns PF ¢J /W ¢J 100 50 15 -50 to +150 NOTES: 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1A, Irr=0.25A 2. Measured at 1 MHz and applied reverse voltage of 4.0 VDC 3. Thermal resistance from junction to ambient and from junction to lead length 0.375"(9.5mm) P.C.B. mounted RATING AND CHARACTERISTIC CURVES UF1000F THRU UF1008F trr +0.5A 0 -0.25 NOTE:1.Rise...