1SMB5926 THRU 1SMB5956
SURFACE MOUNT SILICON ZENER DIODE
VOLTAGE - 11 TO 200 Volts Power - 1.5 Watts
l For surface mounted applications in order to
optimize board space
l Low profile package
l Built-in strain relief
l Glass passivated junction
l Low inductance
l Typical IR less than 1 £gA above 11V
l High temperature soldering :
260 ¢J /10 seconds at terminals
l Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
Case: JEDEC DO-214AA Molded plastic over
Terminals: Solder plated, solderable per MIL-STD-750,
Polarity: Color band denotes positive end (cathode)
Standard Packaging: 12mm tape (EIA-481)
Weight: 0.003 ounce, 0.093 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ¢J ambient temperature unless otherwise specified.
DC Power Dissipation @ TL=75 ¢J , Measure at Zero Lead Length(Note 1, Fig. 1)
Derate above 75 ¢J
Peak forward Surge Current 8.3ms single half sine-wave superimposed on rated
load(JEDEC Method) (Note 1,2)
Operating Junction and Storage Temperature Range
-55 to +150 ¢J
1. Mounted on 5.0mm2(.013mm thick) land areas.
2. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses
per minute maximum.
3. ZENER VOLTAGE (Vz) MEASUREMENT Nominal zener voltage is measured with the device
function in thermal equilibrium with ambient temperature at 25 ¢J .
4.ZENER IMPEDANCE (Zz) DERIVATION ZZT and ZZK are measured by dividing the ac voltage drop across
the device by the accurrent applied. The specified limits are for IZ(ac) = 0.1 IZ, (dc) with the ac freqency = 60Hz.