900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






Peregrine Semiconductor

PE4242 Datasheet Preview

PE4242 Datasheet

SPDT UltraCMOS RF Switch

No Preview Available !

www.DataSheet4U.com
Product Description
The PE4242 UltraCMOS™ RF Switch is designed to cover a
broad range of applications from near DC through 3000 MHz.
This reflective switch integrates on-board CMOS control logic
with a low voltage CMOS-compatible control interface, and can
be controlled using either single-pin or complementary control
inputs. Using a nominal +3-volt power supply voltage, a typical
input 1 dB compression point of +27 dBm can be achieved.
The PE4242 UltraCMOS™ RF Switch is manufactured in
Peregrine’s patented Ultra Thin Silicon (UTSi®) CMOS
process, offering the performance of GaAs with the economy
and integration of conventional CMOS.
Figure 1. Functional Diagram
RFC
RF1 RF2
Product Specification
PE4242
SPDT UltraCMOS™ RF Switch
Features
Single-pin or complementary CMOS
logic control inputs
+3.0-volt power supply needed for
single-pin control mode
Low insertion loss: 0.7 dB at 1000 MHz,
0.9 dB at 2000 MHz
Isolation of 32 dB at 1000 MHz, 23 dB at
2000 MHz
Typical input 1 dB compression point of
+27 dBm
Ultra-small SC-70 package
Figure 2. Package Type
6-lead SC-70
CMOS
Control
Driver
CTRL CTRL or VDD
Table 1. Electrical Specifications @ +25 °C, VDD = 3 V (ZS = ZL = 50 )
Parameter
Conditions
Minimum
Typical
Maximum
Units
Operation Frequency1
Insertion Loss
Isolation
Return Loss
‘ON’ Switching Time
1000 MHz
2000 MHz
1000 MHz
2000 MHz
1000 MHz
2000 MHz
50% CTRL to 0.1 dB of final value, 1 GHz
DC
30
21
18
16
3000
MHz
0.7 0.85 dB
0.9 1.05 dB
32 dB
23 dB
22 dB
18 dB
300 ns
‘OFF’ Switching Time
Video Feedthrough2
Input 1 dB Compression
Input IP3
50% CTRL to 25 dB isolation, 1 GHz
2000 MHz
2000 MHz, 14 dBm input power
200
15
26 27
43 45
ns
mVpp
dBm
dBm
Notes: 1. Device linearity will begin to degrade below 10 MHz.
2. The DC transient at the output of any port of the switch when the control voltage is switched from Low to High or High to Low in a 50 test
set-up, measured with 1ns risetime pulses and 500 MHz bandwidth.
Document No. 70-0095-02 www.psemi.com
©2005 Peregrine Semiconductor Corp. All rights reserved.
Page 1 of 8




Peregrine Semiconductor

PE4242 Datasheet Preview

PE4242 Datasheet

SPDT UltraCMOS RF Switch

No Preview Available !

Figure 3. Pin Configuration (Top View)
pin 1
RF1 1
GND 2
RF2 3
6 CTRL or VDD
5 RFC
4 CTRL
Table 2. Pin Descriptions
Pin Pin
No. Name
Description
1 RF1 RF1 port (Note 1)
2
GND
Ground connection. Traces should be
physically short and connected to
ground plane for best performance.
3 RF2 RF2 port (Note 1)
4
CTRL
Switch control input, CMOS logic level.
5
RFC
Common RF port for switch (Note 1)
6 CTRL or This pin supports two interface options:
VDD Single-pin control mode. A nominal
3-volt supply connection is required.
Complementary-pin control mode. A
complementary CMOS control signal
to CTRL is supplied to this pin. By-
passing on this pin is not required in
this mode.
Note 1: All RF pins must be DC blocked with an external series
capacitor or held at 0 VDC.
PE4242
Product Specification
Table 3. Absolute Maximum Ratings
Symbol Parameter/Conditions Min Max Units
VDD
Power supply voltage
-0.3 4.0
V
VI
Voltage on any input
-0.3
VDD+
0.3
V
TST
Storage temperature range -65 150
°C
TOP Operating temperature range -40 85
°C
PIN Input power (50)
30 dBm
VESD
ESD voltage (Human Body
Model)
1500
V
Table 4. DC Electrical Specifications
Parameter
Min Typ Max Units
VDD Power Supply
Voltage
IDD Power Supply Current
(VDD = 3V, VCTRL = 3V)
Control Voltage High
Control Voltage Low
2.7
0.7x VDD
3.0 3.3
250 500
0.3x VDD
V
nA
V
V
Electrostatic Discharge (ESD) Precautions
When handling this UltraCMOS™ device, observe
the same precautions that you would use with
other ESD-sensitive devices. Although this device
contains circuitry to protect it from damage due to
ESD, precautions should be taken to avoid
exceeding the specified rating.
Latch-Up Avoidance
Unlike conventional CMOS devices, UltraCMOS™
devices are immune to latch-up.
©2005 Peregrine Semiconductor Corp. All rights reserved.
Page 2 of 8
Document No. 70-0095-02 UltraCMOS™ RFIC Solutions


Part Number PE4242
Description SPDT UltraCMOS RF Switch
Maker Peregrine Semiconductor
Total Page 8 Pages
PDF Download

PE4242 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 PE4240 SPST UltraCMOS CATV Switch DC
Peregrine Semiconductor
2 PE4241 SPDT UltraCMOS RF Switch
Peregrine Semiconductor
3 PE4242 SPDT UltraCMOS RF Switch
Peregrine Semiconductor
4 PE42420 UltraCMOS SPDT RF Switch
Peregrine Semiconductor
5 PE42421 RF Switch
Peregrine Semiconductor
6 PE42422 SPDT RF Switch
Peregrine Semiconductor
7 PE42423 SPDT RF Switch
Peregrine Semiconductor
8 PE42424 SPDT RF Switch
Peregrine Semiconductor
9 PE42427 UltraCMOS SPDT RF Switch
Peregrine Semiconductor





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy