Datasheet4U Logo Datasheet4U.com

DEH-2100 - (DEH-xxxx) Manual

Key Features

  • a glass antenna, connect to the antenna booster power supply terminal. When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp’s power terminal. Likewise, do not connect the blue/white lead to the power terminal of the auto-antenna. Such connection could cause excessive current drain and malfunction. To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially, insulate the unused speaker leads without fail. Ther.

📥 Download Datasheet

Datasheet Details

Part number DEH-2100
Manufacturer Pioneer
File Size 222.00 KB
Description (DEH-xxxx) Manual
Datasheet download datasheet DEH-2100 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
DEHR32E472KA2B Capacitor Murata Electronics
DEHR32ExxxKxxx Capacitor Murata Electronics
DEHR32HxxxKxxx Capacitor Murata Electronics
DEHR33AxxxKxxx Capacitor Murata Electronics
DEHR33DxxxKxxx Capacitor Murata Electronics

Other Datasheets by Pioneer

Part Number Description
DEH-2100IB CD RECEIVER Owner Manual
DEH-2100UB CD RDS RECEIVER Operation Manual
DEH-2100UB CD RDS RECEIVER SERVICE MANUAL
DEH-21 Manual
DEH-2110UB CD RDS RECEIVER SERVICE MANUAL

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com Connecting the Units Note: • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. To avoid shorts in the electrical system, be sure to disconnect the ≠ battery cable before beginning installation. Refer to the owner’s manual for details on connecting the power amp and other units, then make connections correctly. Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet.