SMT Power Inductors
High Current Composite Inductor - PA5004.XXXNLT and PM2204.XXXNLT
Height: 3.1mm Max
Footprint: 6.8mm x 6.6mm Max
Current Rating: up to 40Apk
Inductance Range: 0.18uH to 4.5uH
High current, low DCR, and high efficiency
Minimized acoustic noise and minimized leakage flux noise
Available in Commercial (PA5004) and Automotive
Electrical Specifications @ 25°C, Operating Temperature Range per Below4,5
(-40°C to 125°C) (-55°C to 155°C) uH±20%
32 1.6 1.75 40
25 2.25 2.5
22 3 3.31 29
20 4.7 5.17 25
18 5.5 6.05 23
16 6.7 7.4
15 8.3 9.13 20
14 9.2 10.2 18.2
10 11 12.2 15.9
1. Actual temperature of the component during system operation (ambient plus
5. Parts shown in bold are standard catalog parts and are available through sample
temperature rise) must be within the standard operating range.
stock and distribution. Parts in lighter font are available but are not necessarily held
2. The saturation current is the current at which the initial inductance drops approxi-
in sample stock or distribution and lead times may be longer. Please contact Pulse
mately 30% at the stated ambient temperature. This current is determined by placing
the compnent in the specified ambient environment and applying a short duration 6. The PM2204.XXXNLT part numbers are AEC-Q200 and IATF16949 certified. The
pulse current (to eliminate self-heating effect) to the component.
mechanical dimensions are 100% tested in production but do not necessarily meet a
3. The rated current is the DC current required to raise the component temperature by
product capability index (Cpk) >1.33 and therefore may not strictly conform to PPAP.
approximately 40�C. Take note that the components’ performanc varies depending
on the system condition. It is suggested that the component be tested at the system
level, to verify the temperature rise of the component during system operation.
4. The part temperature (ambient+temp rise) should not exceed 125�C under worst
case operating conditions. Circuit design, PCB trace size and thickness, airflow and
other cooling provisions all affect the part temperature. Part temperature should be
verified in the end application.
1 power.pulseelectronics.com P805. B (08/18) http://www.power.pulseelectronics.com/contact