Datasheet4U Logo Datasheet4U.com

RF2629 - 3V CDMA/FM TRANSMIT AGC AMPLIFIER

General Description

The RF2629 is a complete AGC amplifier designed for the transmit section of 3V dual-mode CDMA/FM cellular and PCS applications.

It is designed to amplify IF signals while providing more than 84dB of gain control range.

Key Features

  • RF2629 Absolute Maximum Ratings Parameter Supply Voltage Control Voltage Input Power Levels Operating Ambient Temperature Storage Temperature Rating -0.5 to +7.0 -0.5 to +5.0 +10 -40 to +85 -40 to +150 Unit VDC V dBm °C °C Caution! ESD sensitive device. RF Micro Devices believes the furnished information is correct and accurate at the time of this printing. However, RF Micro Devices reserves the right to make changes to its products without notice. RF Micro Devices does not assume responsibil.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
RF2001 SAW Filter REYCONNS
RF2001 Fast recovery Diodes Rohm
RF2001NS2D Super Fast Recovery Diode ROHM
RF2001NS2DFH Super Fast Recovery Diode ROHM
RF2001NS3D Fast Recovery Diodes Rohm

Other Datasheets by RF Micro Devices (now Qorvo)

Part Number Description
RF2627 3V CDMA RECEIVE AGC AMPLIFIER
RF2628 CDMA/FM UPCONVERTER/BPSK MODULATOR
RF2601 GAIN CONTROLLED IF AMPLIFIER
RF2603 2.8V PCS UPCONVERTER
RF2607 CDMA/FM RECEIVE AGC AMPLIFIER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
RF2629 10 Typical Applications • 3V CDMA/FM Cellular Systems • 3V CDMA PCS Systems • 3V TDMA Cellular/PCS Systems • Supports Dual-Mode AMPS/CDMA • Supports Dual-Mode TACS/CDMA • Portable Battery-Powered Equipment 3V CDMA/FM TRANSMIT AGC AMPLIFIER Product Description The RF2629 is a complete AGC amplifier designed for the transmit section of 3V dual-mode CDMA/FM cellular and PCS applications. It is designed to amplify IF signals while providing more than 84dB of gain control range. Noise Figure, IP3, and other specifications are designed for CDMA and dual mode CDMA/AMPS handsets. This circuit is designed as part of the RFMD CDMA Chip Set, consisting of this Transmit IF AGC Amp, a Transmit Upconverter, a Receive LNA/Mixer, and a Receive IF AGC Amp.