D-607-09
D-607-09 is Coaxial Cable Termination manufactured by Raychem.
Fax-on-Demand: (800) 260-9099 (650) 361-6523 Before ordering check with factory for most current data.
FAX ID 5600
Description Data sheet
Coaxial Cable Termination
Solder Sleeve PCB/coaxial cable terminators
..
Applications Used for terminating coaxial cable to printed circuit boards. Features
/Benefits
- Provides a pletely shielded, low-resistance, matchedimpedance termination with very low VSWR (D-607 series only).
- Transparent Kynar insulation sleeve provides encapsulation, inspectability, strain relief, and insulation.
- Prefluxed solder preform provides a controlled soldering process.
- One-piece design offers easy installation and lower installed cost.
- Preinstalled PCB termination body provides convenience and ease of installation.
Product Options
Product series D-607 B-046
Typical application performance Matched impedance up to 2.3 GHz Effective transmission up to 100 MHz
Shield method Metal body Pin to ground
Product Selection Process
1. Select product series from the Product Options table above. 2. Determine cable RG number or outside diameter dimensions.
3. Select the appropriate part number from Table A (D-607 series) or Table B (B-046 series).
- For D-607 (matched impedance) series, determine straight or right-angle entry to PCB and grid pattern, then select the appropriate part number from Table A below.
- For B-046 (Pin Pak, or pin to ground) series, determine hole spacing and diameter. Refer to Table B for product selection (see illustration beneath Table B for cable dimensions).
Table A. D-607 Series Part Numbers
Cable dimensions (mm/in) Max. outside diameter RG cable number 174, 178, 179, 316, 404 Jacket 1.5- 3.55 (.060- .140) Shield 1.1- 3.15 (.045- .125) Dielectric 0.60- 2.25 (.025- .090)
Part number Entry to PCB Straight grid 5.08 (.200) D-607-09
Right angle grid 5.08 (.200) D-607-10
Straight grid 2.54 (.100) D-607-40-
- Limited for use with RG 174, 178, and 404.
Users should independently evaluate the...
