900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




Renesas Electronics Components Datasheet

ISL6561 Datasheet

Multi-Phase PWM Controller

No Preview Available !

DATASHEET
ISL6561
Multi-Phase PWM Controller with Precision rDS(ON) or DCR Differential Current
Sensing for VR10.X Application
FN9098
Rev 6.00
November 10, 2015
The ISL6561 controls microprocessor core voltage regulation
by driving up to 4 synchronous-rectified buck channels in
parallel. Multi-phase buck converter architecture uses
interleaved timing to multiply channel ripple frequency and
reduce input and output ripple currents. Lower ripple results in
fewer components, lower component cost, reduced power
dissipation, and smaller implementation area.
Microprocessor loads can generate load transients with
extremely fast edge rates. The ISL6561 features a high
bandwidth control loop and ripple frequencies of >4MHz to
provide optimal response to the transients.
Today’s microprocessors require a tightly regulated output
voltage position versus load current (droop). The ISL6561
senses current by utilizing patented techniques to measure
the voltage across the on resistance, rDS(ON), of the lower
MOSFETs or DCR of the output inductor during the lower
MOSFET conduction intervals. Current sensing provides the
needed signals for precision droop, channel-current
balancing, and overcurrent protection.
The accuracy of the current-sensing method is enhanced by
the ISL6561’s temperature compensation function. Droop
accuracy can be affected by increasing rDS(ON) or DCR with
elevated temperature. The ISL6561 uses an internal
temperature-sensing element to provide programmable
temperature compensation. Correctly applied, temperature
compensation can completely nullify the effect of rDS(ON) or
DCR temperature sensitivity.
A unity gain, differential amplifier is provided for remote
voltage sensing. Any potential difference between remote
and local grounds can be completely eliminated using the
remote-sense amplifier. Eliminating ground differences
improves regulation and protection accuracy. The threshold-
sensitive enable input is available to accurately coordinate
the start up of the ISL6561 with any other voltage rail.
Dynamic-VID™ technology allows seamless on-the-fly VID
changes. The offset pin allows accurate voltage offset
settings that are independent of VID setting. The ISL6561
uses 5V bias and has a built-in shunt regulator to allow 12V
bias using only a small external limiting resistor.
Features
• Precision Multi-Phase Core Voltage Regulation
- Differential Remote Voltage Sensing
- 0.5% System Accuracy Over Life, Load, Line and
Temperature
- Adjustable Reference-Voltage Offset
• Precision rDS(ON) or DCR Current Sensing
- Integrated Programmable Temperature Compensation
- Accurate Load-Line Programming
- Accurate Channel-Current Balancing
- Differential Current Sense
- Low-Cost, Lossless Current Sensing
• Internal Shunt Regulator for 5V or 12V Biasing
• Microprocessor Voltage Identification Input
- Dynamic VID™ technology
- 6-Bit VID Input
- 0.8375V to 1.600V in 12.5mV Steps
• Threshold-Sensitive Enable Function for synchronizing
with driver POR
• Overcurrent Protection
• Overvoltage Protection
- No Additional External Components Needed
- OVP Pin to drive opitional Crowbar Device
• 2, 3, or 4 Phase Operation
• Greater Than 1MHz Operation (> 4MHz Ripple)
• Pb-free Available (RoHS Compliant)
• QFN Package Option
- QFN Compliant to JEDEC PUB95 MO-220 QFN - Quad
Flat No Leads - Product Outline
- QFN Near Chip Scale Package Footprint; Improves
PCB Efficiency, Thinner in Profile
FN9098 Rev 6.00
November 10, 2015
Page 1 of 27


Renesas Electronics Components Datasheet

ISL6561 Datasheet

Multi-Phase PWM Controller

No Preview Available !

ISL6561
Ordering Information
PART NUMBER
TEMP.
(°C)
PACKAGE
PKG.
(RoHS Compliant) DWG #
ISL6561IRZ (Note) -40 to 85 40 Ld 6x6 QFN (Pb-free) L40.6x6
ISL6561IRZ-T (Note) 40 Ld 6x6 QFN Tape and Reel
(Pb-free)
L40.6x6
NOTE: Intersil Pb-free products employ special Pb-free material sets;
molding compounds/die attach materials and 100% matte tin plate
termination finish, which are RoHS compliant and compatible with both
SnPb and Pb-free soldering operations. Intersil Pb-free products are
MSL classified at Pb-free peak reflow temperatures that meet or exceed
the Pb-free requirements of IPC/JEDEC J STD-020.
Pinout
ISL6561 (40-PIN QFN)
TOP VIEW
40 39 38 37 36 35 34 33 32 31
VID4 1
VID3 2
VID2 3
VID1 4
VID0 5
VID12.5 6
GND 7
OFS 8
TCOMP 9
DAC 10
30 ISEN4+
29 ISEN4-
28 ISEN2-
27 ISEN2+
26 PWM2
25 PWM1
24 ISEN1+
23 ISEN1-
22 ISEN3-
21 ISEN3+
11 12 13 14 15 16 17 18 19 20
FN9098 Rev 6.00
November 10, 2015
Page 2 of 27


Part Number ISL6561
Description Multi-Phase PWM Controller
Maker Renesas
Total Page 27 Pages
PDF Download

ISL6561 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 ISL6560 Microprocessor CORE Voltage Regulator Two-Phase Buck PWM Controller
Renesas
2 ISL6561 Multi-Phase PWM Controller
Renesas
3 ISL6562 Microprocessor CORE Voltage Regulator Two-Phase Buck PWM Controller
Renesas
4 ISL6563 Two-Phase Multiphase Buck PWM Controller
Renesas
5 ISL6564 Multiphase PWM Controller
Renesas
6 ISL6564A Multiphase PWM Controller
Renesas
7 ISL6565 Multi-Phase PWM Controller with Precision rDS(ON) or DCR Current Sensing for VR10.X Application
Intersil Corporation
8 ISL6565A Multi-Phase PWM Controller
Renesas
9 ISL6565B Multi-Phase PWM Controller
Renesas





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy