L7983 Datasheet | STMicroelectronics

Features - 3.5 V to 60 V operating input voltage - Fixed output voltage (3.3 V and 5 V) or adjustable from 0.85 V to VIN - 300 m A DC output current - Dynamic low consumption mode to low noise mode selection - 10 µA operating quiescent current (L7983PU33R, VIN > 24 V, LCM) - 2.3 µA shutdown current - 200 k Hz to 2.2 MHz programmable switching frequency - Optional spread spectrum (dithering) - Internal soft-start - Enable / adjustable UVLO threshold - Synchronization to external clock - Internal pensation network - Internal current limiting - Overvoltage protection - Output voltage sequencing - Thermal shutdown Applications - Designed for 12 V, 24 V and 48 V buses - Battery powered applications - Decentralized intelligent nodes - Fail safe system - Sensors and low noise applications (LNM) Description The L7983 device is a step-down monolithic switching regulator able to deliver up to 300 m A DC based on peak current mode architecture. The output voltage adjustability ranges from 0.85 V to VIN. The wide input voltage range and adjustable UVLO threshold meet the specification for the 12 V, 24 V and 48 V industrial bus standards. The “Low Consumption Mode” (LCM) is designed for applications active during idle mode, so it maximizes the efficiency at light load with controlled output voltage ripple. The “Low Noise Mode” (LNM) makes the switching frequency constant overload current range, meeting the low noise application specification. The L7983 supports dynamic LCM to LNM transition. The soft-start time is internally fixed and the output voltage supervisor manages the reset phase for any digital load (microcontroller, FPGA, etc.). The internal pensation network features high noise immunity, simple design and saves on the ponent cost. The RST open collector output can also implement output voltage sequencing during the power-up phase. DS13354 - Rev 1 - October 2020 For further information contact your local STMicroelectronics sales office. .st. The synchronous...