Datasheet4U Logo Datasheet4U.com

L99MOD51XP - Multi-output driver

General Description

The L99MOD51XP is a microcontroller-driven multifunctional actuator driver for automotive applications.

Up to two DC motors and two grounded resistive loads can be driven with three half bridges and two hide-side drivers.

Key Features

  • AEC-Q100 qualified.
  • One half bridge for 7.4 A load (RDSon = 150 mΩ).
  • Two half bridges for 5 A load (RDSon = 200 mΩ).
  • Two high-side drivers for 1.25 A load (RDSon = 800 mΩ).
  • Programmable soft start function to drive loads with higher inrush currents (i. e. current > 7.4 A, >5 A, >1.25 A).
  • Very low current consumption in standby mode (IS < 3 μA, typ. , Tj  85 °C).
  • All outputs short circuit protected.
  • Current monitor output for all high-side drivers Applicati.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
L9911 Car alternator multifunction smart voltage regulator ST Microelectronics
L9942 Integrated stepper motor driver ST Microelectronics
L99PM62XP Power Management ST Microelectronics

Other Datasheets by STMicroelectronics

Part Number Description
L99MOD50XP Multi-output driver
L99MOD53XP Multi-output driver
L99MC6 Configurable 6-channel device
L99MM70XP Integrated microprocessor
L9907 Automotive FET driver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
L99MOD51XP Multi-output driver for automotive applications Datasheet - production data  All outputs over temperature protected  Open-load diagnostic for all outputs  Overload diagnostic for all outputs  Programmable PWM control of all outputs  Charge pump output for reverse polarity protection Features  AEC-Q100 qualified  One half bridge for 7.4 A load (RDSon = 150 mΩ)  Two half bridges for 5 A load (RDSon = 200 mΩ)  Two high-side drivers for 1.25 A load (RDSon = 800 mΩ)  Programmable soft start function to drive loads with higher inrush currents (i.e.current > 7.4 A, >5 A, >1.25 A)  Very low current consumption in standby mode (IS < 3 μA, typ.