900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




STMicroelectronics Electronic Components Datasheet

TCPP01-M12 Datasheet

USB type-C port protection

No Preview Available !

TCPP01-M12
Datasheet
USB type-C port protection
Product labels
Features
• Overvoltage protection on VBUS, adjustable up to 22 V, with external N-channel
MOSFET
• 6.0 V overvoltage protection (OVP) on CC lines against short-to-VBUS
• System-level ESD protection for USB type-C connector pins (CC1, CC2),
compliant with IEC 61000-4-2 level 4 (±8 kV contact discharge, ±15 kV air
discharge)
• Integrated charge pump to control the gate of an external N-channel MOSFET
(which features a lower RDSON than a P-channel MOSFET)
• Null quiescent current when no USB charging cable is attached for battery-
operated "consumer/sink" applications
• Integrated “dead battery” (RD resistors)
• Over temperature protection (OTP)
• Operating junction temperature from -40°C to 85°C
• Complies with the latest USB type-C and USB power delivery standards
• Compliant with programmable power supply (PPS) as defined in latest USB PD
specification
• Open-drain fault reporting
ECOPACK2 compliant
Product status link
TCPP01-M12
Product summary
Order code
TCPP01-M12
Package
QFN12
Packing
Tape and reel
Description
PPS compliant
USB type-C port
protection
Companion chip
USB Type-C
STM32 or STM8
USB Type-C with
power delivery
STM32 with
UCPD support,
example
STM32L5,
STM32G0,
STM32G4
Applications
• USB type-C used in sink configuration (consumer)
• USB type-C used in source configuration (provider)
• USB type-C for UFP (upstream facing port) or DFP (downstream facing port)
configuration
• USB type-C power delivery, PPS compliant
Description
The TCPP01-M12 (type-C port protection) is a single chip solution for USB type-C
port protection that facilitates the migration from USB legacy connectors type-A or
type-B to USB type-C connectors. The TCPP01-M12 features 22 V tolerant ESD
protection as per IEC61000-4-2 level 4 on USB type-C connector configuration
channel (CC) pins. For a safe and reliable USB type-C implementation, the TCPP01-
M12 provides overvoltage protection on CC1 and CC2 pins when these pins are
subjected to short circuit with the VBUS pin that may happen when removing the
USB type-C cable from its receptacle. For sink applications, TCPP01-M12 triggers an
external N-MOSFET on VBUS line when a defective power source applies a voltage
higher than selected OVP threshold. Also, the TCPP01-M12 integrates a “dead
battery” management logic that is compliant with the latest USB power delivery
specification. The power supply of the TCPP01-M12 for sink applications operated
with a battery can be provided by an MCU 3.3 V GPIO in order to drop the power
consumption in “cable not attached” condition down to 0 nA. This low power mode
will extend the battery operating life when no source equipment is attached.
The TCPP01-M12 can also be used to protect source (provider) applications, and it
can support programmable power supply feature from the USB-C power delivery
specification.
DS12900 - Rev 1 - September 2019
For further information contact your local STMicroelectronics sales office.
www.st.com


STMicroelectronics Electronic Components Datasheet

TCPP01-M12 Datasheet

USB type-C port protection

No Preview Available !

1 Pinout and functions
Figure 1. QFN12 pinout (top view)
12 11
10
TCPP01-M12
Pinout and functions
1 CC 2
2 GND
3 CC 1
13
Exposed pad
(GND)
CC 2c 9
IN _GD 8
CC 1c 7
4 56
Table 1. Pinout and functions
Name Pin #
Type
Description
CC2
1 Input / Output USB-PD controller side for the CC2 pin
GND
2 Ground Ground
CC1
3 Input / Output USB-PD controller side for the CC1 pin
SOURCE
4
Power VBUS N-channel MOSFET's SOURCE
GATE 5 Output VBUS N-channel MOSFET's GATE
VBUS_CTRL 6
Input
Input voltage setting the VBUS OVP threshold by external resistor bridge
CC1c
7 Input / Output Connector side for CC1 OVP internal FET
IN_GD
8
Power VBUS N-channel MOSFET's DRAIN, input of the N-channel MOSFET gate driver
CC2c
9 Input / Output Connector side for CC2 OVP internal FET
DB/
10
Input
Dead battery resistors management
FLT/
11
Output
Fault reporting flag (open-drain), triggered by either OVP (overvoltage protection), OTP
(overtemperature protection), or UVLO (undervoltage lockout) event.
VCC
12
Input
3.3 V power supply
Exposed pad 13
Ground Ground
DS12900 - Rev 1
page 2/25


Part Number TCPP01-M12
Description USB type-C port protection
Maker STMicroelectronics
Total Page 25 Pages
PDF Download

TCPP01-M12 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 TCPP01-M12 USB type-C port protection
STMicroelectronics





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy