900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




Sanyo Electric Components Datasheet

LC87F7DJ2B Datasheet

8-bit 1-chip Microcontroller

No Preview Available !

www.DataSheet.co.kr
Ordering number : ENA1636A
LC87F7DJ2B
CMOS IC
FROM 192K byte, RAM 8K byte on-chip
8-bit 1-chip Microcontroller
Overview
The SANYO LC87F7DJ2B is an 8-bit microcomputer that, centered around a CPU running at a minimum bus cycle time
of 83.3ns, integrates on a single chip a number of hardware features such as 192K-byte flash ROM (onboard
programmable), 8K-byte RAM, an on-chip debugger, an LCD controller/driver, sophisticated 16-bit timer/counter (may
be divided into 8-bit timers), a 16-bit timer/counter (may be divided into 8-bit timers/counters or 8-bit PWMs), four 8-bit
timers with a prescaler, 16-bit timer with a prescaler (may be divided into 8-bit timers), a base timer serving as a time-of-
day clock, a day and time counter, a synchronous SIO interface (with automatic block transmission/reception
capabilities), an asynchronous/synchronous SIO interface, two UART interface (full duplex), a 12-bit 15-channel AD
converter, two 12-bit PWM channels, a high-speed clock counter, a system clock frequency divider, a small signal
detector, two infrared remote controller receiver function, and a 31-source 10-vector interrupt feature.
Features
„Flash ROM
Capable of on-board-programming with a wide range of souce voltages: 3.0 to 5.5V
Block-erasable in 2-byte units
196608 × 8 bits
„RAM
8192 × 9 bits
„Minimum Bus Cycle Time
66.6ns (15MHz)
125ns (8MHz)
250ns (4MHz)
VDD=3.0 to 5.5V
VDD=2.5 to 5.5V
VDD=2.2 to 5.5V
Note: The bus cycle time here refers to the ROM read speed.
* This product is licensed from Silicon Storage Technology, Inc. (USA), and manufactured and sold by
SANYO Semiconductor Co., Ltd.
Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to
"standard application", intended for the use as general electronics equipment (home appliances, AV equipment,
communication device, office equipment, industrial equipment etc.). The products mentioned herein shall not be
intended for use for any "special application" (medical equipment whose purpose is to sustain life, aerospace
instrument, nuclear control device, burning appliances, transportation machine, traffic signal system, safety
equipment etc.) that shall require extremely high level of reliability and can directly threaten human lives in case
of failure or malfunction of the product or may cause harm to human bodies, nor shall they grant any guarantee
thereof. If you should intend to use our products for applications outside the standard applications of our
customer who is considering such use and/or outside the scope of our intended standard applications, please
consult with us prior to the intended use. If there is no consultation or inquiry before the intended use, our
customer shall be solely responsible for the use.
Specifications of any and all SANYO Semiconductor Co.,Ltd. products described or contained herein stipulate
the performance, characteristics, and functions of the described products in the independent state, and are not
guarantees of the performance, characteristics, and functions of the described products as mounted in the
customer's products or equipment. To verify symptoms and states that cannot be evaluated in an independent
device, the customer should always evaluate and test devices mounted in the customer's products or
equipment.
Ver.0.07
20310HKIM 20100118-S00001 No.A1636-1/26
Datasheet pdf - http://www.DataSheet4U.net/


Sanyo Electric Components Datasheet

LC87F7DJ2B Datasheet

8-bit 1-chip Microcontroller

No Preview Available !

www.DataSheet.co.kr
„Minimum Instruction Cycle Time (tCYC)
200ns (15MHz)
375ns (8MHz)
750ns (4MHz)
VDD=3.0 to 5.5V
VDD=2.5 to 5.5V
VDD=2.2 to 5.5V
LC87F7DJ2B
„Ports
Normal withstand voltage I/O ports
Ports whose I/O direction can be designated in 1 bit units 29 (P0n, P1n, P70 to P73, P8n, XT2)
Normal withstand voltage input port
1 (XT1)
LCD ports
Segment output
54 (S00 to S53)
Common output
4 (COM0 to COM3)
Bias terminals for LCD driver
3 (V1 to V3)
Other functions
Input/output ports
54(P3n, PAn, PBn, PCn, PDn, PEn, PFn)
Input ports
7 (PLn)
Dedicated oscillator ports
2 (CF1, CF2)
Reset pin
Power pins
1 (RES)
6 (VSS1 to VSS3, VDD1 to VDD3)
„LCD Controller
1) Seven display modes are available (static, 1/2, 1/3, 1/4 duty × 1/2, 1/3 bias)
2) Segment output and common output can be switched to general-purpose input/output ports
„Small Signal Detection (MIC signals etc)
1) Counts pulses with the level which is greater than a preset value
2) 2-bit counter
„Timers
Timer 0: 16-bit timer/counter with two capture registers.
Mode 0: 8-bit timer with an 8-bit programmable prescaler (with two 8-bit capture registers) × 2 channels
Mode 1: 8-bit timer with an 8-bit programmable prescaler (with two 8-bit capture registers)
+ 8-bit counter (with two 8-bit capture registers)
Mode 2: 16-bit timer with an 8-bit programmable prescaler (with two 16-bit capture registers)
Mode 3: 16-bit counter (with two 16-bit capture registers)
Timer 1: 16-bit timer/counter that supports PWM/toggle outputs
Mode 0: 8-bit timer with an 8-bit prescaler (with toggle outputs)
+ 8-bit timer/counter with an 8-bit prescaler (with toggle outputs)
Mode 1: 8-bit PWM with an 8-bit prescaler × 2 channels
Mode 2: 16-bit timer/counter with an 8-bit prescaler (with toggle outputs)
(toggle outputs also possible from the lower-order 8 bits)
Mode 3: 16-bit timer with an 8-bit prescaler (with toggle outputs)
(The lower-order 8 bits can be used as PWM.)
Timer 4: 8-bit timer with a 6-bit prescaler
Timer 5: 8-bit timer with a 6-bit prescaler
Timer 6: 8-bit timer with a 6-bit prescaler (with toggle output)
Timer 7: 8-bit timer with a 6-bit prescaler (with toggle output)
Timer 8: 16-bit timer
Mode 0: 8-bit timer with an 8-bit prescaler × 2 channels
Mode 1: 16-bit timer with an 8-bit prescaler
Base timer
1) The clock is selectable from the subclock (32.768kHz crystal oscillation), system clock,
and timer 0 prescaler output.
2) Interrupts programmable in 5 different time schemes
Day and time counter
1) Using with a base timer, it can be used as 65000 day + minute + second counter.
No.A1636-2/26
Datasheet pdf - http://www.DataSheet4U.net/


Part Number LC87F7DJ2B
Description 8-bit 1-chip Microcontroller
Maker Sanyo Semicon Device
Total Page 26 Pages
PDF Download

LC87F7DJ2B Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 LC87F7DJ2B 8-bit 1-chip Microcontroller
Sanyo Semicon Device
2 LC87F7DJ2C 8-bit 1-chip Microcontroller
Sanyo Semicon Device
3 LC87F7DJ2C 8-bit 1-chip Microcontroller
ON Semiconductor





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy