16SEP330M Datasheet | SANYO

4. SPECIFICATIONS FOR EACH SERIES Conductive polymer type .. Standard radial lead type, Series Guaranteed at 105°C for 3,000h This is a radial lead type using conductive polymer based on the SVP series. Lead free-flow is supported. Specifications Items Category temperature range Tolerance on rated capacitance Tangent of loss angle Leakage current 1 ESR Characteristics of impedance ratio at high temp. and low temp. Endurance Conditions 120Hz 120Hz After 2 minutes Based the value at 100KHz +20°C 105°C, 3,000h, Rated voltage applied (2.5V→2,000h), (25V→20V applied) 60°C, 90 to 95%RH, 1,000h, No-applied voltage Flow method (260±5°C X 10s) Damp heat (Steady state) Resistance to soldering heat Marking : Polarity( ), Rated voltage, Rated capacitance (Purple) Lot.No., SEP Characteristics -55°C to +105°C M :±20% Less than or equal to the value of Table10 Less than or equal to the value of Table10 Less than or equal to the value of Table10 Z / Z 20°C 0.75 to 1.25 -55°C 0.75 to 1.25 Z / Z 20°C +105°C ∆C/C Within ±20% tanδ 1.5 times or less than an initial standard ESR 1.5 times or less than an initial standard Leakage current Below an initial standard ∆C/C Within ±20% tanδ 1.5 times or less than an initial standard ESR 1.5 times or less than an initial standard Leakage current Below an initial standard (after voltage processing) ∆C/C Within ±5% tanδ Below an initial standard ESR Below an initial standard Leakage current Below an initial standard (after voltage processing) 1 In case of some problems for measured values, measure after applying rated voltage for 2.5 to 20V products or temperature derating voltage for 25V products for 120 minutes at 105°C . Dimensions φD φd (unit : mm) Size Code φD±0.5 6.3 8.0 10.0 8.0 10.0 Lmax. 6.0 7.0 8.0 12.0 13.0 F 2.5±0.5 3.5±0.5 5.0±0.5 3.5±0.5 5.0±0.5 φd±0.05 0.45 0.45 0.50 0.60 0.60 C6 E7 F8 15min. L 19min. 4min. E12 F13 Size List µF 6.8 10 22 33 39 47 56 68 82 100 120 150 180 220 270 330 470...