Datasheet4U Logo Datasheet4U.com

EClamp2465T - ESD/EMI Protection

Description

The EClampTM2465T is a combination EMI filter and line termination device with integrated TVS diodes for use on SIM Card interfaces on cellular phones and other portable electronics.

Features

  • ‹ Bidirectional EMI/RFI filter with integrated TVS for ESD protection ‹ ESD protection to IEC 61000-4-2 (ESD) Level 4, ±15kV (air), ±8kV (contact) ‹ TVS working voltage: 5V ‹ Termination Resistors: 100 Ohms & 47 Ohms ‹ Capacitance: 10pF (Typical at VR = 0V) ‹ Protection and filtering for four lines ‹ Solid-state technology Mechanical Characteristics ‹ SLP1713P8T 8-pin package ‹ RoHS/WEEE Compliant ‹ Nominal Dimensions: 1.7 x 1.3 x 0.40 mm ‹ Lead Pitch: 0.4mm ‹ Lead finish: NiPdAu ‹ Marking: Mark.

📥 Download Datasheet

📁 Similar Datasheet

  • EClamp2455K - ESD/EMI Protection (Semtech Corporation)
  • EClamp2455P - ESD/EMI Protection (Semtech Corporation)
  • EClamp2340C - Emi Filter And Esd Protection (Semtech Corporation)
  • ECLAMP2342N - ESD/EMI Protection (Semtech Corporation)
  • EClamp1002A - ESD/EMI Protection (Semtech Corporation)
  • EClamp3202A - ESD/EMI Protection (Semtech Corporation)
  • EClamp8052P - 2-Line Common Mode Filter and Low Capacitance ESD Protection (Semtech Corporation)
  • ECL06B03 - Schottky Barrier Diode (Kyocera)
  • ECL06B03 - Schottky Barrier Diode (Nihon Inter Electronics)
  • ECL06B03-F - Schottky Barrier Diode (Kyocera)
Other Datasheets by Semtech

Full PDF Text Transcription

Click to expand full text
PROTECTION PRODUCTS - EMIClampTM Description The EClampTM2465T is a combination EMI filter and line termination device with integrated TVS diodes for use on SIM Card interfaces on cellular phones and other portable electronics. This state-of-the-art device utilizes solid-state silicon-avalanche technology for superior clamping performance and DC electrical characteristics. The device consists of three circuits that include series impedance matching resistors for proper termination of the SIM card interface. Termination resistor value of 100 Ohms is included on the Reset and Data lines and 47 Ohms on the CLK line. TVS diodes are also included on each line for ESD protection in excess of ±15kV (air discharge) and ±8kV (contact discharge) per IEC 610004-2, level 4.
Published: |