EDGE4717D - Per Pin Precision Measurement

Product Overview

Semtech Corporation

Part number	EDGE4717D
Manufacturer	Semtech Corporation
File Size	241.73 KB
Description	Per Pin Precision Measurement
Datasheet	EDGE4717D Datasheet
Additional preview pages of the EDGE4717D datasheet.

The Edge4717D is a precision measurement unit designed for automated test equipment and instrumentation.

a PMU that can force or measure voltage over a typical 15V I/O range, and supports 4 current ranges: ± 3.2 µA, ± 80 µA, ± 2 mA, ± 30 mA. The Edge4717D has an on-board window comparator per channel that provides two bits of information.
DUT too high and DUT too low. There is also a monitor pin which provides a real time analog signal proportional to either the voltage or current measured at the DUT. The Edge4717D is designed to be a low power, low cost, small footprint solution to allow.

📁 Similar Datasheet

Edge118 - Low Skew Clock Spreader (Semtech)
Edge142 - Per Pin timing Deskew w 4x2 Cross Point Switch (Semtech)
Edge646 - Pin Electronics Driver/ Window Comparator/ and Switch Matrix (Semtech)
Edge647 - Pin Electronics Driver/ Window Comparator/ and Switch Matrix (Semtech)
Edge649 - Octal Pin Electronics Driver/Receiver (Semtech)
Edge692 - 200 MHz Monolithic Dual Pin Electronics Driver (Semtech)
Edge693 - 500 MHz Monolithic Dual Pin Electronics Driver (Semtech)
Edge710 - 500 MHz Pin Electronics Driver/ Window Comparator/ and Load (Semtech)

Other Datasheets by Semtech Corporation

Published: Jan 27, 2011 |