SC620 Datasheet | SEMTECH

Octal LED Driver, General Purpose Current Sink with Serial Interface POWER MANAGEMENT Features - - - - - - - - - - - Description The SC620 is a multi-purpose LED driver with eight identical, independently controlled current sinks. Each current sink can drive an LED by connecting the LED’s anode to the system power supply and the cathode to the current sink input pin. Any bination of outputs can be enabled or disabled for optimal design flexibility. The SC620 also employs an adjustable global current gain setting register to allow the current setting step size to vary from 31.25μA to 500μA. This provides a wide range of options for LED variation and dimming functions. The maximum output is also scaled by this step size, with a maximum of 25m A at the highest step setting. Multi-colored and white LEDs with different forward voltages can be driven using the same SC620 due to its floating cathode technology. This feature allows each output pin to vary in voltage from 150m V to VIN - 1.5V. All current control is programmed using an I2C interface bus. Only a single input bypass capacitor is required - no other external resistors or capacitors are needed. The 3mm x 3mm MLPQ package and minimal support ponents make the SC620 an ideal solution for low-cost, area-conscious backlighting designs. Wide current setting range - 31.25μA to 25m A Eight identical current drivers with independent control 5% current matching, 7% accuracy I2C interface for microprocessor control I2C slave address 1110 000x Less than 1μA quiescent current in shutdown Low dropout voltage - ≤ 150m V Over-temperature protection MLPQ-UT-16 package (3mm x 3mm) Ultra-thin 0.6mm maximum package height Fully WEEE and Ro HS pliant Applications - - LCD backlighting LED driver Multicolor and RGB LED driver - General purpose current sink array - General purpose digital output (open-drain) expander - Auto-focus voice-coil driver .. Typical Application Circuit LED Backlighting Battery...