SC627 Datasheet | SEMTECH

LED Light Management Unit POWER MANAGEMENT Features - - - - - - - - - - - - - - - - Charge Pump, 4 LEDs, 700m A Flash LED, Dual LDOs, and Sem Wire TM Interface Description The SC627 is a high efficiency charge pump LED driver using Semtech’s proprietary m Ah XLife TM technology. Performance is optimized for use in single-cell Li-ion battery applications. The charge pump provides backlight current in conjunction with four matched current sinks. It also can supply continuous or bursted current to a flash LED using the dedicated flash driver current sink. The load and supply conditions determine whether the charge pump operates in 1x, 1.5x, or 2x mode. An optional fading feature that gradually adjusts the backlight current is provided to simplify control software. A flash-timeout feature disables the flash if active for longer than 1 second. The SC627 also provides two low-dropout, low-noise linear regulators for powering a camera module or other peripheral circuits. The SC627 uses the proprietary Sem Wire TM single wire interface. The interface controls all functions of the device, including backlight and flash currents as well as two LDO voltage outputs. The single wire implementation minimizes microcontroller and interface pin counts. The flash/spotlight output is triggered via either the Sem Wire interface or a dedicated pin. In sleep mode, the device reduces quiescent current to 100μA while continuing to monitor the serial interface. The two LDOs can be enabled when the device is in sleep mode. Total current reduces to 0.1μA in shutdown. MAIN BACKLIGHT FLASH Input supply voltage range - 3.0V to 5.5V Charge pump modes - 1x, 1.5x and 2x Four programmable current sinks with 32 steps from 0.5m A to 25m A Flash LED - 700m A max in flash mode, 250m A max continuous for spotlight Two user-configurable 100m A low-noise LDO regulators Charge pump frequency - 250k Hz Sem Wire TM single wire interface - up to 75kbit/s Backlight current accuracy ±1.5% typical Backlight current...