Datasheet4U Logo Datasheet4U.com

HV895 - Liquid Lens Driver

General Description

The HV895 is designed to drive liquid lenses of up to 200pF with a 1.5kHz waveform at amplitudes up to 60VRMS, controlled via an I2C interface.

A single byte (AMP) written to the HV895 controls the operation of the driver.

Setting AMP = 01h to FFh controls output amplitude in 255 monotonic steps.

Key Features

  • Drives capacitive loads up to 200pF.
  • Programmable drive amplitude (up to 60VRMS).
  • On-chip boost converter.
  • No external inductor www. DataSheet4U. com.
  • I2C interface.
  • Low operating current (≤20mA).
  • Low standby current (≤1.0µA).
  • Controlled drive edge reduces EMI.
  • 1.0mm × 6.0mm flip-chip General.

📥 Download Datasheet

Datasheet Details

Part number HV895
Manufacturer Supertex
File Size 526.51 KB
Description Liquid Lens Driver
Datasheet download datasheet HV895 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HV809 Off-Line High Voltage EL Lamp Driver Supertex Inc
HV823 High Voltage EL Lamp Driver IC Supertex Inc
HV825 High Voltage EL Lamp Driver Supertex Inc
HV826 High Voltage EL Lamp Driver Supertex Inc
HV830 High Voltage EL Lamp Driver Supertex Inc

Other Datasheets by Supertex

Part Number Description
HV892 Inductorless Liquid Lens Driver
HV816 Dimmable EL Lamp Driver
HV824 High Voltage EL Lamp Driver
HV829A High Voltage EL Lamp Driver
HV829B High Voltage EL Lamp Driver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
HV895 Liquid Lens Driver Features ► Drives capacitive loads up to 200pF ► Programmable drive amplitude (up to 60VRMS) ► On-chip boost converter ► No external inductor www.DataSheet4U.com ► I2C interface ► Low operating current (≤20mA) ► Low standby current (≤1.0µA) ► Controlled drive edge reduces EMI ► 1.0mm × 6.0mm flip-chip General Description The HV895 is designed to drive liquid lenses of up to 200pF with a 1.5kHz waveform at amplitudes up to 60VRMS, controlled via an I2C interface. A single byte (AMP) written to the HV895 controls the operation of the driver. Setting AMP = 01h to FFh controls output amplitude in 255 monotonic steps. Setting AMP = 00h causes the HV895 to go into low power standby mode, consuming less than 1.0µA. When active, the HV895 draws less than 20mA.