900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






TOKO

TK71750S Datasheet Preview

TK71750S Datasheet

LOW DROPOUT VOLTAGE REGULATOR

No Preview Available !

TK717xxS
LOW DROPOUT VOLTAGE REGULATOR
FEATURES
n Very Good Stability (CL = 0.22 mF is Stable For
Any Type Capacitor withVOUT ³ 1.8 V)
n Built-in Shunt Circuit of Output to GND. The Stored
Energy of the Output Capacitor is Discharged
Quickly
n Wide Operating Voltage Range (1.8 V ~ 14 V)
n Very Low Dropout Voltage (V = 103 mV at
DROP
100 mA)
n Peak Output Current is 370 mA (0.3 V DROP Point)
n Very Low Quiescent Current (IQ = 72 uA at IOUT = 0 mA)
n Good Ripple Rejection Ratio (80 dB at 1 kHz)
n High Precision Output Voltage (± 1.5 % or ± 50 mV)
n Suitable for Very Low Noise Applications
n Built-in Active High On/Off Control (0.1 mA Max
Standby Current)
n Built-in Short Circuit Protection
n Built-in Thermal Shutdown
n Very Small Surface Mount Package (SOT23-5)
APPLICATIONS
n Battery Powered Systems
n Measurement Systems
n Mobile Communications Systems
n Cordless Phone, PHS, GSM, CDMA
n Industrial Equipment
n Personal Computers, Barcode Readers
low quiescent current of 72 mA at no load and 0.8 mA with
a 50 mA load. The standby current is typically 100 pA. The
circuit features very good stability. The ripple rejection is 90
dB at 400 Hz and 80 dB at 1 kHz. Stable operation is
achieved with an output capacitor as low as 0.22 mF; a
capacitor of any type may be used. (However, the larger the
output capacitor is, the better the overall characteristics will
be.)
The TK717xxS is available in a very small SOT23-5 surface
mount package.
TK717xxS
DESCRIPTION
TK717xxS is a low dropout linear regulator with a built-in
electronic switch. The internal switch can be controlled by
TTL or CMOS logic levels. The device is in the ON state
when the control pin is pulled to a logic high level. In the OFF
state, the output impedance becomes very low, quickly
discharging the output capacitor. An external capacitor can
be connected to the noise bypass pin to lower the output
noise level to 30 ~ 50 mVRMS. An internal PNP pass transistor
is included to achieve a low dropout voltage of 103 mV at
100 mA load current. The TK717xx has an exceptionally
ORDERING INFORMATION
TK717 S L
Voltage Code
Package Code
Tape/Reel Code
Operating Temp. Range
VOLTAGE CODE
15 = 1.5 V 24 = 2.4 V
16 = 1.6 V 25 = 2.5 V
17 = 1.7 V 26 = 2.6 V
18 = 1.8 V 27 = 2.7 V
19 = 1.9 V 28 = 2.8 V
20 = 2.0 V 29 = 2.9 V
21 = 2.1 V 30 = 3.0 V
22 = 2.2 V 31 = 3.1 V
23 = 2.3 V 32 = 3.2 V
33 = 3.3 V
34 = 3.4 V
35 = 3.5 V
36 = 3.6 V
37 = 3.7 V
38 = 3.8 V
39 = 3.9 V
40 = 4.0 V
41 = 4.1 V
42 = 4.2 V
43 = 4.3 V
44 = 4.4 V
45 = 4.5 V
46 = 4.6 V
47 = 4.7 V
48 = 4.8 V
49 = 4.9 V
50 = 5.0 V
TAPE/REEL CODE
L: Tape Left
OPERATING TEMP. RANGE
C: -30 ~ 80°C
PACKAGE CODE
S: SOT23-5
VIN
GND01S
CONTROL
VOUT
NOISE
BYPASS
BLOCK DIAGRAM
VIN
CONTROL
CONTROL CIRCUIT
CONSTANT
CURRENT
SOURCE
BANDGAP
REFERENCE
THERMAL &
OVER CURRENT
PROTECTION
VOUT
+
-
AUTO
DISCHARGE
CIRCUIT
GND
NOISE
BYPASS
October 2001 TOKO, Inc.
Page 1




TOKO

TK71750S Datasheet Preview

TK71750S Datasheet

LOW DROPOUT VOLTAGE REGULATOR

No Preview Available !

TK717xxS
ABSOLUTE MAXIMUM RATINGS
Supply Voltage ............................................... -0.4 to16 V Operating Temperature Range ..................... -30 to +80 °C
Power Dissipation (Note 1) ................................. 500 mW Noise Bypass Pin Voltage .............................. -0.4 to 5 V
Reverse Bias Voltage ..................................... -0.4 to 6 V Control Pin Voltage ....................................... -0.4 to 16 V
Operating Voltage Range ............................... 1.8 to 14 V Short Circuit Current ............................................ 410 mA
Storage Temperature Range ..................... -55 to +150 °C
TK717xxSCL ELECTRICAL CHARACTERISTICS
Test conditions: TA = 25 °C, unless otherwise specified.
SYMBOL
PARAMETER
VOUT Output Voltage
Line Reg Line Regulation
Load Reg Load Regulation
V
DROP
Dropout Voltage
(Note 5)
IOUT (MAX) Maximum Output Current
IQ Quiescent Current
ISTBY Standby Current
IGND GND Pin Current
Idis Discharge Current
TEST CONDITIONS
VIN = VOUT(TYP) + 1 V to VOUT(TYP) + 6 V, D V = 5 V
5 mA < IOUT < 100 mA, Note 2
5 mA < IOUT < 200 mA, Note 2
I = 50 mA
OUT
IOUT = 100 mA
IOUT = 200 mA (2.4 V £ VOUT)
IOUT = 180 mA (2.1 V £ VOUT < 2.4 V)
When VOUT Down 0.3 V, Note 2
1.8 V £ VIN £ 2.1 V, Reference Value
IOUT = 0 mA Excluding ICONT
VCC = 8 V, VCONT £ 0.15 V, Off Mode
IOUT = 50 mA
VREV = 2 V, Off Mode (71720)
VREV = 3 V, Off Mode (71730)
VREV = 4 V, Off Mode (71740)
VREV = 5 V, Off Mode (71750)
MIN TYP MAX UNITS
See Table 1
0.3 5
mV
8 24 mV
27 61 mV
65 130 mV
103 200 mV
163 300 mV
163 300 mV
280 370
mA
250
72 110
mA
mA
0.0 0.1 mA
0.8 1.5 mA
13 29
mA
23 38
mA
25 41
mA
27 44
mA
Page 2
October 2001 TOKO, Inc.


Part Number TK71750S
Description LOW DROPOUT VOLTAGE REGULATOR
Maker TOKO
Total Page 13 Pages
PDF Download

TK71750S Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 TK71750S LOW DROPOUT VOLTAGE REGULATOR
TOKO





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy