4 LED Module
(20 modules / string)
Absolute Maximum Ratings (TA = 25o C unless otherwise noted)
Storage Temperature Range
-40 ~ +80 °C
Operating Temperature Range
-30 ~ +50 °C
LED Junction Temperature
Electrostatic Discharge Classification (JEDEC-JESD22-A114F)
1. Lead Solder time less than 10 seconds at temperature extreme.
2. No Heat sink is required if the string is operated at ambient temperature < 35°C. For long term performance the drive voltage between 12
V and 18 V is recommended. Please contact an Optek sales representative for more information on recommended drive conditions.
Electrical Characteristics / module (TA = 25o C unless otherwise noted)
50% Power Angle
MIN TYP MAX
- - - 14
- - - See chart
---- 120 ----
VDC = 18 V
VDC = 18 V
If an entire string is not required for the application, clip wires at mid-span.
Modules can be secured onto a mounting surface with two #1 screws. Modules are waterproof and can be used
outdoors. The installer is responsible for waterproofing the connection to the power source. The installer is also
responsible for the use of an exterior approved power source.
1 tray contains 4 strings of 20 modules each.
Modules are packaged 80 per tray.
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Issue D 05/2011
Page 2 of 2
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747
FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com