LM7824 Datasheet | Thinki Semiconductor

Features - - - - - - Output Voltage Range 5 to 24V Output current up to 1A No external ponents required Internal thermal overload protection Internal short-circuit current limiting Output transistor safe-area pensation - Output voltage offered in 4% tolerance TO-220M-1 Unit : (mm) Standard Application Circuit A mon ground is required between the input and the output voltages. The input voltage must remain typically 2.0V above the output voltage even during the low point on the Input ripple voltage. XX = these two digits of the type number indicate voltage. - = Cin is required if regulator is located an appreciable distance from power supply filter. - - = Co is not needed for stability; however, it does improve transient response. Absolute Maximum Rating (Ta = 25o C unless otherwise noted) Parameter Input Voltage Output Current Power Dissipation Operating Junction Temperature Storage Temperature Range Thermal Resistance - Junction to Case Thermal Resistance - Junction to Ambient TO-220 ITO-220 TO-220 ITO-220 VOUT=5~18V VOUT=24V Symbol VIN IOUT PD TJ TSTG RӨJC RӨJA Limit 35 40 Internal Limited Internal Limited 0~+125 -65~+150 5 5 50 60 Unit V o o C C o C/W C/W o Note: Absolute maximum ratings are those values beyond which damage to the device may occur. Functional operation under these condition is not implied. Page 1/7 © 2006 Thinki Semiconductor Co.,Ltd. http://.thinkisemi./ Free Datasheet http://../ LM78XX LM7805 Electrical Characteristics o o ® (Vin=10V, Iout=500m A, 0 C≤Tj≤125 C, Cin=0.33u F, Cout=0.1u F; unless otherwise specified.) Parameter Output voltage Symbol o Test Condition Tj=25 C 7.5V≤Vin≤20V, 10m A≤Iout≤1A, PD≤15W o 7.5V≤Vin≤25V Tj=25 C 8V≤Vin≤12V o 10m A≤Iout≤1A Tj=25 C 250m A≤Iout≤750m A o Iout=0, Tj=25 C 7.5V≤Vin≤25V 10m A≤Iout≤1A o 10Hz≤f≤100KHz, Tj=25 C f=120Hz, 8V≤Vin≤18V o Iout=1.0A, Tj=25 C f=1KHz o Tj=25 C o Tj=25 C Iout=10m A, 0 C≤Tj≤125 C o o Min 4.80 4.75 --------62...