900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




Toshiba Electronic Components Datasheet

TLP2166A Datasheet

Photocoupler

No Preview Available !

TOSHIBA PHOTOCOUPLER IRED & PHOTO-IC
TLP2166A
TLP2166A
Plasma Display Panels (PDPs)
High-Speed Interfaces
3.3-V Voltage Source
Unit: mm
The Toshiba TLP2166A consists of an infrared emitting diode and an
integrated high-gain, high-speed photodetector.
The TLP2166A is housed in the 8-pin SO package.
Since the TLP2166A contains two photocouplers, it saves board space.
The TLP2166A operates with a 3.3-V supply voltage.
Inverting logic output (totem-pole output)
SO8 package
Guaranteed performance over -40 to 100°C
Power supply voltage: 3.0 to 3.6 V
Input threshold current: IFHL = 3 mA (max)
Switching time (tpHL / tpLH): 75 ns (max)
Switching speed: 15 MBd (typ.)(NRZ)
Common-mode transient immunity: ±15 kV/μs
Isolation voltage: 2500 Vrms
UL-recognized: UL 1577, File No.E67349
cUL-recognized: CSA Component Acceptance Service No.5A
File No.E67349
VDE-approved: EN 60747-5-5 (Note 1)
JEDEC
JEITA
TOSHIBA
115K1S
Weight: 0.11 g (typ.)
Note 1 : When a VDE approved type is needed, please designate the Option(V4).
Truth Table
Input
H
L
LED1(2)
ON
OFF
M1(3)
OFF
ON
M2(4)
ON
OFF
Output 1(2)
L
H
Pin Configuration (Top View)
Schematic
IF1
1
VF1
2
LED1
ICC 8
VCC
M1
IO1 7
VO1
M2
1
VCC 8 1: ANODE 1
2: CATHODE 1
2
7 3: CATHODE 2
4: ANODE 2
3
6
5: GND
6: VO2 (Output2)
4
GND
SHIELD
5
7: VO1 (Output1)
8: VCC
SHIELD
A bypass capacitor of 0.1μF must be
connected between pins 8 and 5.
3LED2
VF2
4
M3
IO2 6
M4
VO2
IF2
5
SHIELD
GND
© 2019
1
Toshiba Electronic Devices & Storage Corporation
Start of commercial production
2008-07
2019-06-03


Toshiba Electronic Components Datasheet

TLP2166A Datasheet

Photocoupler

No Preview Available !

Absolute Maximum Ratings (Ta=25°C)
TLP2166A
CHARACTERISTIC
SYMBOL RATING UNIT
Forward Current
Forward Current Derating (Ta 95°C)
Peak Transient Forward Current
Reverse Voltage
(Note 1)
IF
15
(Note 1) IF/Ta -0.5
(Note 1, 2) IFP
1
(Note 1)
VR
5
mA
mA/°C
A
V
Input Power Dissipation
(Note 1)
PD
40
mW
Input Power Dissipation Derating (Ta 95°C)
(Note 1) PD/°C
-1.3
mW/°C
Output Current
(Note 1)
IO
10
mA
Output Voltage
(Note 1)
VO
6
V
Supply Voltage
VCC
6
V
Output Power Dissipation
PO
40
mW
Output Power Dissipation Derating (Ta 25°C)
PO/°C
-0.4
mW/°C
Operating Temperature Range
Topr -40 to 100
°C
Storage Temperature Range
Tstg -55 to 125
°C
Lead Soldering Temperature
(10 s)
Tsol
260
°C
Isolation Voltage (AC, 60 s, R.H.60 %)
(Note 3)
BVS
2500
Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant
change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the
operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report
and estimated failure rate, etc).
Note 1: Each Channel.
Note 2: Pulse width 1 μs, 300 pps.
Note 3: This device is regarded as a two terminal device: pins 1, 2, 3 and 4 are shorted together,
as are pins 5, 6, 7 and 8.
Recommended Operating Conditions
CHARACTERISTIC
SYMBOL MIN TYP. MAX UNIT
Input Current, ON
Input Voltage, OFF
(Note 1)
IF(ON)
5
(Note 1) VF(OFF)
0
10
mA
0.8
V
Supply Voltage*
Operating Temperature
(Note 4)
VCC
Topr
3.0
3.3
3.6
V
-40
100
°C
* This item denotes operating range, not meaning of recommended operating conditions.
Note 4: The detector of this product requires a power supply voltage (VCC) of 3.0 V or higher for stable operation.
If the VCC is lower than this value, an ICCH may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off
Note: A ceramic capacitor (0.1 μF) should be connected from pin 8 (VCC) to pin 5 (GND) to stabilize the operation of
the high gain linear amplifier. Failure to provide the bypass may impair the switching property.
The total lead length between capacitor and coupler should not exceed 1 cm.
© 2019
2
Toshiba Electronic Devices & Storage Corporation
2019-06-03


Part Number TLP2166A
Description Photocoupler
Maker Toshiba
PDF Download

TLP2166A Datasheet PDF






Similar Datasheet

1 TLP2166A Photocoupler
Toshiba





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z



Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy