TLP2310 Datasheet | Toshiba

Photocouplers Ga AℓAs Infrared LED & Photo IC 1. Applications - Programmable Logic Controllers (PLCs) - Battery Management System (BMS) - Industrial Inverters 2. General The TLP2310 is a 5-Mbps low-power photocoupler in the small SO6 package. The TLP2310 consumes supply current (IDDL/IDDH) of only 0.3 m A maximum over the entire operating temperature range of -40  to 125  and operates at a supply voltage as low as 2.7 V, contributing to a reduction in power consumption of various systems. The input forward current can be less than 1 m A maximum, allowing direct drive by a microcontroller. The detector has a totem-pole output stage with current sourcing and sinking capabilities. The TLP2310 has an internal Faraday shield that provides a guaranteed mon-mode transient immunity of ±25 k V/µs. 3. Features (1) Package: SO6 (2) Data transfer rate: 5 MBd (typ.) (NRZ) (3) Supply current: 0.3 m A (max) (4) Threshold input current: 1.0 m A (max) (5) Supply voltage: 2.7 to 5.5 V (6) Operating temperature: -40 to 125  (7) Propagation delay time: 250 ns (max) (8) Pulse width distortion: 30 ns (max) (9) Isolation voltage: 3750 Vrms (min) (10) Safety standards UL-approved: UL1577, File No.E67349 c UL-approved: CSA ponent Acceptance Service No.5A File No.E67349 VDE-approved: EN60747-5-5, EN60065 or EN60950-1 (Note 1) CQC-approved: GB4943.1, GB8898 Thailand Factory Note 1: When a VDE approved type is needed, please designate the Option (V4). ©2016 Toshiba Corporation Start of mercial production 2015-04 2016-04-13 Rev.3.0 4. Packaging and Pin Assignment 11-4L1S 5. Internal Circuit (Note) 1: Anode 3: Cathode 4: GND 5: VO(Output) 6: VDD Note: A 0.1-µF bypass capacitor must be connected between pin 6 and pin 4. 6. Principle of Operation 6.1. Truth Table Input H L LED ON OFF Output H L 6.2. Mechanical Parameters Characteristics Creepage distances Clearance distances Internal isolation thickness Dimension(Min) Unit 5.0...