VKL060
VKL060 is LCD Driver manufactured by Yongjia.
Features
- Operating voltage：2.5-5.5V
- Built-in 32k Hz RC oscillator
- Selection of 1/2 or 1/3 bias
- 1/4duty(4)
- Built-in 15x4 bits display RAM
- 80Hz Frame Frequency
- STANDBY mode（by System Set mand LCD OFF）
- Four power consumption modes can be configured
- I2C bus interface
- Display mode 15x4
- Versatile blinking modes
- Software configuration LCD parameters
- Read/Write address auto increment
- VLCD pin for adjusting LCD operating voltage(≤(VDD-VLCD)）
- Built-in power on reset circuit (POR)
- - TEST2 =0 enable
- Low power consumption、High anti-interference
- Package:
SSOP24L(150mil) (8.65mm x 3.9mm PP=0.635mm)
15×4 LCD DRIVER
)HEUXDU
5HY
.szvinka.
1 General Description
15×4 LCD DRIVER
VKL060 is a RAM Mapping LCD Driver，It can support LCD screens with a maximum of 60 pattern(15SEGx4) .The device municates with host microcontrollers via a two-line bidirectional
I2C bus,it is used to configure display parameters and transfer display data, , and can also enter the standby mode through System Set mand .Four power consumption modes can be configured. With the characteristics of high anti-interference and low power consumption, it is suitable for water electrical meters and industrial control instruments.
February 2020
Rev. 1.3
2/23
.szvinka.
2 Pinouts and pin description
2.1 VKL060 SSOP24 Pin Assignment
15×4 LCD DRIVER
GND SCL SDA SEG11 SEG12 SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19
24...
