Datasheet4U Logo Datasheet4U.com

LM8335 - General Purpose Output Expander

Description

The LM8335 General Purpose Output Expander is a dedicated device to provide flexible and general purpose, host programmable output expansion functions.

This device communicates with a host processor through a MIPI® RFFE Interface (Mobile Industry Processor Interface RF Front-End).

Features

  • 1.
  • 2 MIPI RFFE Interface Version 1.10 Compliant.
  • Supports Output Expansion.
  • Host Interface Address Select Pin:.
  • ADR=GND, USID[3:0]=0001.
  • ADR=VDD, USID[3:0]=1001.
  • Pin-Configurable Initial State: VIO.
  • CFG=GND, GPO High-z, with Weak Internal Pull-Down Resistor Enabled; GPO_OUT_DATA is Unmasked.
  • CFG=VDD, GPO High-z, with Weak Internal Pull-Down Resistor Enabled; GPO_OUT_DATA is Masked.
  • Three Sources for Chip Reset:.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LM833 DUAL OPERATIONAL AMPLIFIER Motorola Inc
LM833 Dual Audio Operational Amplifier National Semiconductor
LM833 DUAL OPERATIONAL AND LOW VOLTAGE NOISE AMPLIFIER Unisonic Technologies
LM833 Audio Dual Operational Amplifier ON Semiconductor
LM833 Low noise dual operational amplifier STMicroelectronics

Other Datasheets by Texas Instruments

Part Number Description
LM833 Dual High-Speed Audio Operational Amplifier
LM833-N Dual Audio Operational Amplifier
LM8330 Keypad Controller
LM8333 Mobile I/O Companion Supporting Key-Scan
LM8300 Four Wire Resistive Touchscreen Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
LM8335 www.ti.com SNVS840B – JUNE 2012 – REVISED MAY 2013 LM8335 General Purpose Output Expander with MIPI® RFFE Host Interface Check for Samples: LM8335 FEATURES 1 •2 MIPI RFFE Interface Version 1.10 Compliant • Supports Output Expansion • Host Interface Address Select Pin: – ADR=GND, USID[3:0]=0001 – ADR=VDD, USID[3:0]=1001 • Pin-Configurable Initial State: VIO – CFG=GND, GPO High-z, with Weak Internal Pull-Down Resistor Enabled; GPO_OUT_DATA is Unmasked – CFG=VDD, GPO High-z, with Weak Internal Pull-Down Resistor Enabled; GPO_OUT_DATA is Masked • Three Sources for Chip Reset: – VIO Input Pin – POR – Software-Commanded Reset APPLICATIONS: • Smart Handheld Devices • RF Transceiver Applications KEY SPECIFICATIONS • 1.8 ± 0.15V MIPI RFFE Operation (VIO) • 1.8 ± 0.
Published: |