900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






etcTI

LP2901-Q1 Datasheet Preview

LP2901-Q1 Datasheet

Low-Power Quad Differential Comparator

No Preview Available !

LP2901-Q1
www.ti.com................................................................................................................................................ SLCS148A – SEPTEMBER 2005 – REVISED APRIL 2008
LOW-POWER QUAD DIFFERENTIAL COMPARATOR
FEATURES
1
Qualified for Automotive Applications
Wide Supply-Voltage Range . . . 3 V to 30 V
Ultra-Low Power-Supply Current
Drain . . . 60 µA Typ
Low Input Biasing Current . . . 3 nA
Low Input Offset Current . . . ±0.5 nA
Low Input Offset Voltage . . . ±2 mV
Common-Mode Input Voltage Includes Ground
Output Voltage Compatible With MOS and
CMOS Logic
High Output Sink-Current Capability
(30 mA at VO = 2 V)
Power-Supply Input Reverse Voltage Protected
Single Power-Supply Operation
Pin-for-Pin Compatible With LM239, LM339,
LM2901
D PACKAGE
(TOP VIEW)
1OUT
2OUT
VCC
2IN −
2IN +
1IN −
1IN +
1
2
3
4
5
6
7
14 3OUT
13 4OUT
12 GND
11 4IN +
10 4IN −
9 3IN +
8 3IN −
DESCRIPTION/ORDERING INFORMATION
The LP2901 is a low-power quadruple differential comparator. The device consists of four independent voltage
comparators designed specifically to operate from a single power supply and, typically, to draw 60-µA drain
current over a wide range of voltages. Operation from split power supplies also is possible, and the ultra-low
power-supply drain current is independent of the power-supply voltage.
Applications include limit comparators, simple analog-to-digital converters, pulse generators, square-wave
generators, time-delay generators, voltage-controlled oscillators, multivibrators, and high-voltage logic gates. The
LP2901 is designed specifically to interface with the CMOS logic family. The ultra-low power-supply current
makes these products desirable in battery-powered applications.
The LP2901 is characterized for operation from –40°C to 85°C.
ORDERING INFORMATION(1)
TA
–40°C to 85°C
VIOMAX
AT 25°C
±5 mV
PACKAGE (2)
ORDERABLE PART NUMBER
TOP-SIDE MARKING
SOIC – D
Reel of 2500 LP2901IDRQ1
LP2901IQ1
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
(2) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2005–2008, Texas Instruments Incorporated




etcTI

LP2901-Q1 Datasheet Preview

LP2901-Q1 Datasheet

Low-Power Quad Differential Comparator

No Preview Available !

LP2901-Q1
SLCS148A – SEPTEMBER 2005 – REVISED APRIL 2008................................................................................................................................................ www.ti.com
SCHEMATIC DIAGRAM (EACH COMPARATOR)
VCC
0.2 µA
5 µA
0.2 µA
6 µA
IN+
OUT
IN−
GND
Absolute Maximum Ratings(1)
over operating free-air temperature range (unless otherwise noted)
VCC
VID
VI
II
θJA
TA
TJ
Tlead
Tstg
Supply voltage(2)
Differential input voltage range(3)
Input voltage range (either input)
Input current(4)
Duration of output short-circuit to ground(5)
Continuous total power dissipation(6)
Package thermal impedance(7)(8)
Operating free-air temperature range
Operating virtual junction temperature
Lead temperature range
Storage temperature range
VI –0.3 V
1,6 mm (1/16 in) from case for 60 s
MIN MAX UNIT
36 V
±36 V
–0.3 36 V
–50 mA
Unlimited
See Dissipation Rating
Table
133.5 °C/W
–40 85 °C
150 °C
300 °C
–65 150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values, except differential voltages, are with respect to the network ground.
(3) Differential voltages are at IN+ with respect to IN–.
(4) This input current exists only when the voltage at any of the inputs is driven negative. The current flows through the collector-base
junction of the input clamping device. In addition to the clamping device action, there is lateral n-p-n parasitic transistor action. This
action is not destructive, and normal output states are reestablished when the input voltage returns to a value more positive than –0.3 V
at TA = 25°C.
(5) Short circuits between outputs to VCC can cause excessive heating and eventual destruction.
(6) If the output transistors are allowed to saturate, the low-bias dissipation and the on-off characteristics of the outputs keep the dissipation
very small (usually less than 100 mW).
(7) Maximum power dissipation is a function of TJ(max), θJA, and TA. The maximum allowable power dissipation at any allowable ambient
temperature is PD = (TJ(max) – TA)/θJA. Operating at the absolute maximum TJ of 150°C can impact reliability.
(8) The package thermal impedance is calculated in accordance with JESD 51 (low-K board).
Dissipation Ratings
PACKAGE
D
TA 25°C
POWER RATING
936 mW
DERATING
FACTOR ABOVE
TA = 25°C
7.49 mW/°C
TA = 70°C
POWER RATING
599 mW
TA = 85°C
POWER RATING
486 mW
2 Submit Documentation Feedback
Product Folder Link(s): LP2901-Q1
Copyright © 2005–2008, Texas Instruments Incorporated


Part Number LP2901-Q1
Description Low-Power Quad Differential Comparator
Maker etcTI
Total Page 10 Pages
PDF Download

LP2901-Q1 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 LP2901-Q1 Low-Power Quad Differential Comparator
etcTI





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy