MSP430FR2111 Datasheet | Texas Instruments

Features - Embedded microcontroller - 16-bit RISC architecture up to 16 MHz - Wide supply voltage range from 3.6 V down to 1.8 V (minimum supply voltage is restricted by SVS levels, see the SVS specifications) - Optimized low-power modes (at 3 V) - Active mode: 120 µA/MHz - Standby - LPM3.5 with VLO: 1 µA - Real-time clock (RTC) counter (LPM3.5 with 32768-Hz crystal): 1 µA - Shutdown (LPM4.5): 34 n A without SVS - High-performance analog - 8-channel 10-bit analog-to-digital converter (ADC) - Integrated temperature sensor - Internal 1.5-V reference - Sample-and-hold 200 ksps - Enhanced parator (e P) - Integrated 6-bit DAC as reference voltage - Programmable hysteresis - Configurable high-power and low-power modes - Low-power ferroelectric RAM (FRAM) - Up to 3.75KB of nonvolatile memory - Built-in error correction code (ECC) - Configurable write protection - Unified memory of program, constants, and storage - 1015 write cycle endurance - Radiation resistant and nonmagnetic - Intelligent digital peripherals - One 16-bit timer with three capture/pare registers (Timer_B3) - One 16-bit counter-only RTC counter - 16-bit cyclic redundancy checker (CRC) - Enhanced serial munications - Enhanced USCI A (e USCI_A) supports UART, Ir DA, and SPI - Clock system (CS) - On-chip 32-k Hz RC oscillator (REFO) - On-chip 16-MHz digitally controlled oscillator (DCO) with frequency-locked loop (FLL) - ±1% accuracy with on-chip reference at room temperature - On-chip very-low-frequency 10-k Hz oscillator (VLO) - On-chip high-frequency modulation oscillator...