900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






etcTI

MSP430FR2310 Datasheet Preview

MSP430FR2310 Datasheet

Mixed-Signal Microcontrollers

No Preview Available !

Product
Folder
Order
Now
Technical
Documents
Tools &
Software
Support &
Community
Reference
Design
MSP430FR2311, MSP430FR2310
SLASE58D – FEBRUARY 2016 – REVISED AUGUST 2018
MSP430FR231x Mixed-Signal Microcontrollers
1 Device Overview
1.1 Features
1
• Embedded Microcontroller
– 16-Bit RISC Architecture up to 16 MHz
– Wide Supply Voltage Range From 3.6 V Down
to 1.8 V (Minimum Supply Voltage is Restricted
by SVS Levels, See the SVS Specifications)
• Optimized Low-Power Modes (at 3 V)
– Active Mode: 126 µA/MHz
– Standby: Real-Time Clock (RTC) Counter
(LPM3.5 With 32768-Hz Crystal): 0.71 µA
– Shutdown (LPM4.5): 32 nA Without SVS
• High-Performance Analog
– Transimpedance Amplifier (TIA) (1)
– Current-to-Voltage Conversion
– Half-Rail Input
– Low-Leakage Negative Input Down to 5 pA,
Enabled on TSSOP16 Package Only
– Rail-to-Rail Output
– Multiple Input Selections
– Configurable High-Power and Low-Power
Modes
– 8-Channel 10-Bit Analog-to-Digital Converter
(ADC)
– Internal 1.5-V Reference
– Sample-and-Hold 200 ksps
– Enhanced Comparator (eCOMP)
– Integrated 6-Bit Digital-to-Analog Converter
(DAC) as Reference Voltage
– Programmable Hysteresis
– Configurable High-Power and Low-Power
Modes
– Smart Analog Combo (SAC-L1)
– Supports General-Purpose Op Amp
– Rail-to-Rail Input and Output
– Multiple Input Selections
– Configurable High-Power and Low-Power
Modes
• Low-Power Ferroelectric RAM (FRAM)
– Up to 3.75KB of Nonvolatile Memory
– Built-In Error Correction Code (ECC)
– Configurable Write Protection
– Unified Memory of Program, Constants, and
Storage
– 1015 Write Cycle Endurance
(1) The transimpedance amplifier was originally given an
abbreviation of TRI in descriptive text, pin names, and register
names. The abbreviation has changed to TIA in all descriptive
text, but pin names and register names still use TRI.
1
– Radiation Resistant and Nonmagnetic
• Intelligent Digital Peripherals
– IR Modulation Logic
– Two 16-Bit Timers With Three Capture/Compare
Registers Each (Timer_B3)
– One 16-Bit Counter-Only RTC Counter
– 16-Bit Cyclic Redundancy Checker (CRC)
• Enhanced Serial Communications
– Enhanced USCI A (eUSCI_A) Supports UART,
IrDA, and SPI
– Enhanced USCI B (eUSCI_B) Supports SPI and
I2C With Support for New Remap Feature (See
Signal Descriptions)
• Clock System (CS)
– On-Chip 32-kHz RC Oscillator (REFO)
– On-Chip 16-MHz Digitally Controlled Oscillator
(DCO) With Frequency Locked Loop (FLL)
– ±1% Accuracy With On-Chip Reference at
Room Temperature
– On-Chip Very Low-Frequency 10-kHz Oscillator
(VLO)
– On-Chip High-Frequency Modulation Oscillator
(MODOSC)
– External 32-kHz Crystal Oscillator (LFXT)
– External High-Frequency Crystal Oscillator up to
16 MHz (HFXT)
– Programmable MCLK Prescalar of 1 to 128
– SMCLK Derived From MCLK With
Programmable Prescalar of 1, 2, 4, or 8
• General Input/Output and Pin Functionality
– 16 I/Os on 20-Pin Package
– 12 Interrupt Pins (8 Pins of P1 and 4 Pins of P2)
Can Wake MCU From LPMs
– All I/Os are Capacitive Touch I/Os
• Development Tools and Software
– LaunchPad™ Development Kit
(MSPEXP430FR2311)
– Target Development Board (MSPTS430PW20)
• Family Members (Also See Device Comparison)
– MSP430FR2311: 3.75KB of Program FRAM +
1KB of RAM
– MSP430FR2310: 2KB of Program FRAM + 1KB
of RAM
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.




etcTI

MSP430FR2310 Datasheet Preview

MSP430FR2310 Datasheet

Mixed-Signal Microcontrollers

No Preview Available !

MSP430FR2311, MSP430FR2310
SLASE58D – FEBRUARY 2016 – REVISED AUGUST 2018
www.ti.com
• Package Options
– 20-Pin TSSOP (PW20)
– 16-Pin TSSOP (PW16)
– 16-Pin VQFN (RGY16)
1.2 Applications
• Smoke Detectors
• Power Banks
• Portable Health and Fitness
• For Complete Module Descriptions, See the
MSP430FR4xx and MSP430FR2xx Family User's
Guide
• Power Monitoring
• Personal Electronics
1.3 Description
The MSP430FR231x FRAM microcontrollers (MCUs) are part of the MSP430™ MCU value line sensing
family. The devices integrate a configurable low-leakage transimpedance amplifier (TIA) and a general
purpose operational amplifier. The MCUs feature a powerful 16-bit RISC CPU, 16-bit registers, and a
constant generator that contribute to maximum code efficiency. The digitally controlled oscillator (DCO)
also allows the device to wake up from low-power modes to active mode typically in less than 10 µs. The
feature set of these MCUs are well suited for applications ranging from smoke detectors to portable health
and fitness accessories.
The ultra-low-power MSP430FR231x MCU family consists of several devices that feature embedded
nonvolatile FRAM and different sets of peripherals targeted for various sensing and measurement
applications. The architecture, FRAM, and peripherals, combined with extensive low-power modes, are
optimized to achieve extended battery life in portable and wireless sensing applications. FRAM is a
nonvolatile memory technology that combines the speed, flexibility, and endurance of SRAM with the
stability and reliability of flash at lower total power consumption.
The MSP430FR231x MCUs are supported by an extensive hardware and software ecosystem with
reference designs and code examples to get your design started quickly. Development kits include the
MSPEXP430FR2311 LaunchPad™ development kit and the MSPTS430PW20 20-pin target
development board. TI provides free MSP430Ware™ software, which is available as a component of
Code Composer Studio™ IDE desktop and cloud versions within TI Resource Explorer. The MSP430
MCUs are also supported by extensive online collateral, training, and online support through the E2E™
Community Forum.
PART NUMBER
Device Information(1)
PACKAGE
BODY SIZE(2)
MSP430FR2311IPW20
MSP430FR2310IPW20
TSSOP (20)
6.5 mm × 4.4 mm
MSP430FR2311IPW16
MSP430FR2310IPW16
TSSOP (16)
5 mm × 4.4 mm
MSP430FR2311IRGY
MSP430FR2310IRGY
VQFN (16)
4 mm × 3.5 mm
(1) For the most current part, package, and ordering information, see the Package Option Addendum in
Section 9, or see the TI website at www.ti.com.
(2) The sizes shown here are approximations. For the package dimensions with tolerances, see the
Mechanical Data in Section 9.
2 Device Overview
Copyright © 2016–2018, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: MSP430FR2311 MSP430FR2310


Part Number MSP430FR2310
Description Mixed-Signal Microcontrollers
Maker etcTI
Total Page 30 Pages
PDF Download

MSP430FR2310 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 MSP430FR2310 Mixed-Signal Microcontrollers
etcTI
2 MSP430FR2311 Mixed-Signal Microcontrollers
etcTI





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy