MSP430G2333 Datasheet | Texas Instruments

Overview 1.1 Features - Low Supply-Voltage Range: 1.8 V to 3.6 V - Ultra-Low Power Consumption - Active Mode: 230 µA at 1 MHz, 2.2 V - Standby Mode: 0.5 µA - Off Mode (RAM Retention): 0.1 µA - Five Power-Saving Modes - Ultra-Fast Wake up From Standby Mode in Less Than 1 µs - 16-Bit RISC Architecture, 62.5-ns Instruction Cycle Time - Basic Clock Module Configurations - Internal Frequencies up to 16 MHz With Four Calibrated Frequencies - Internal Very-Low-Power Low-Frequency (LF) Oscillator - 32-k Hz Crystal - External Digital Clock Source - Two 16-Bit Timer_A With Three Capture/pare Registers - Up to 24 Capacitive-Touch Enabled I/O Pins - Universal Serial munication Interface (USCI) - Enhanced UART Supports Automatic Baud Rate Detection (LIN) - Ir DA Encoder and Decoder - Synchronous SPI - I2C - 10-Bit 200-ksps Analog-to-Digital Converter (ADC) With Internal Reference, Sample-and-Hold, and Autoscan (See Table 3-1) - Brownout Detector - Serial Onboard Programming, No External Programming Voltage Needed, Programmable Code Protection by Security Fuse - On-Chip Emulation Logic With Spy-Bi-Wire Interface - Section 3 Summarizes Available Family Members - Package Options - TSSOP: 20 Pin, 28 Pin - PDIP: 20 Pin - QFN: 32 Pin - For plete Module Descriptions, See the MSP430x2xx Family User’s Guide (SLAU144) 1.2 Applications - Power Management - Sensor Interface - Capacitive...