SN75C3222E Datasheet | Texas Instruments

Features - ESD Protection for RS-232 bus pins - ±15-k V Human-body model (HBM) - ±8-k V IEC 61000-4-2, Contact discharge - ±15-k V IEC 61000-4-2, Air-gap discharge - Meet or exceed the requirements of TIA/EIA-232-F and ITU v.28 standards - Operate with 3-V to 5.5-V VCC supply - Operate up to 1000 kbit/s - Two drivers and two receivers - Low standby current . . . 1 μA Typ - External capacitors . . . 4 × 0.1 μF - Accepts 5-V Logic Input with 3.3-V supply 2 Applications - Industrial PCs - Wired Networking - Data center and networking equipment - Notebooks - Hand-held equipment 3 Description The SN65C3222E and SN75C3222E consist of two line drivers, two line receivers, and a dual chargepump circuit with ±15-k V ESD protection pin to pin (serial-port connection pins, including GND). The devices meet the requirements of TIA/EIA-232F and provide the electrical interface between an asynchronous munication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The devices operate at typical data signaling rates up to 1000 kbit/s and are improved drop-in replacements for industry-popular '3222 twodriver, two-receiver functions. The SN65C3222E and SN75C3222E can be placed in the power-down mode by setting the power-down ( PWRDOWN) input low, which draws only 1 μA from the power supply. When the devices are powered down, the receivers remain active while the drivers are placed in the high-impedance state. Also, during power down, the onboard charge pump is disabled; V+ is lowered to VCC, and V- is raised toward GND. Receiver outputs also can be placed in the highimpedance state by setting enable ( EN) high. PART NUMBER SN65C3222E SN75C3222E Device Information PACKAGE(1) BODY SIZE (NOM) DB (SSOP) (20) 10.2 mm x 5.30 mm DW (SOIC) (20) 15.4 mm x 7.50 mm PW (TSSOP) (20) 7.80 mm v 4.40 mm (1) For all available packages, see the orderable addendum at the end of the data sheet. 13...