TS003
Key Features
- Enter your secret code (PIN): The telephone remote control is equipped with a factory setting code : 0000. Personalise your secret code: 1. Dial your telephone number the TS003 answers after 6 or 7 rings ands asks your access (secret) code (PIN) 2. Enter the factory setting code : 0000. 3. Press the button on your telephone, the TS003 voice guide will guide you through the instructions. TS003 confirms your code (PIN). (If you make 3 mistakes in entering your code (PIN), TS003 hangs up. You can then call back and try again). 4. Hang up. In case you have forgotten or want to change your code, please press the reset button, TS003 resets the factory setting code (PIN) 0000
- Remote control : A. To turn a circuit ON or OFF : 1. Call your telephone number TS003 answers after 6 or 7 rings, and asks you for your access code (PIN). 2. Enter your 4 digit secret code. The TS003 wele message tells you if each of the 3 circuits (1, 2 and 3 in order) is ON, OFF or set for timed switch-off. 3. Follow the voice-guide instructions to turn the circuits ON or OFF or hang up. You can change the setting for a circuit, without listening to the whole message, by holding down key 1, 2, 3, depending on which circuit you want to change the setting for (circuit 1, 2, 3). B. To program a circuit for timed switch-off You can program each of the circuits to switch off automatically after 1 to 100 hours, in 1 hour increments. In this case, you only turn the circuit ON, it will switch-off automatically at the end of the programmed time period. 1. Call your telephone number. TS003 answers after 6 or 7 rings, and asks you for your access code (PIN). 2. Enter your 4 digit secret code. 3. Press the button and TS003 will guide you Choose the circuit you want a timed switch-off for, and program the duration of delay before switch off. 4. Press button ࠻ in order to switch ON the circuit of your choice. After this configuration the circuit is always programmed for timed switch-off. You can cancel the timer by following the above mentioned steps and by entering a duration of delay of 0 hrs. The circuit will return to the configuration ON or OFF
