Datasheet4U Logo Datasheet4U.com

HY5640 - Subminiature Controller

Description

of the HY5640 Pin Outs

The temperature set resistor for the HY5640 controls the temperature at which the TEC will operate.

When the circuit has stabilized, the resistance of the thermistor will be equal to that of the set resistor Rs.

Features

  • ✦ ✦ ✦ ✦ ✦ ✦ ✦ ✦ Proportional/Integral (PI) control Small size Drive current to +/.
  • 2 amps Operation to 12 volts Control above/below ambient Temperature stability of 0.01°C Single supply operation Thru-hole or surface-mount packaging option Laser Diode Drivers Figure 1 400 Hot Springs Road, Carson City NV 89706.
  • (775) 883-0820.
  • Fax (775) 883-0827.
  • www. hytek. com.
  • 1 Micro-heaters HY5640 TEC Controller.

📥 Download Datasheet

Datasheet preview – HY5640

Datasheet Details

Part number HY5640
Manufacturer hytek
File Size 515.82 KB
Description Subminiature Controller
Datasheet download datasheet HY5640 Datasheet
Additional preview pages of the HY5640 datasheet.

📁 Similar Datasheet

  • HY5608A - N-Channel Enhancement Mode MOSFET (HOOYI)
  • HY5608W - N-Channel Enhancement Mode MOSFET (HOOYI)
  • HY5-P - Current Transducers HY 5 to 25-P (LEM)
  • HY50-P - Current Transducer HY 50-P (LEM)
  • HY5002 - 1-chip composed of high-current totem pole (HAWYANG)
  • HY5012A - N-Channel Enhancement Mode MOSFET (HOOYI)
  • HY5012W - N-Channel Enhancement Mode MOSFET (HOOYI)
  • HY50P - Current Transducers/ HY 50-P/SP1 (LEM)
  • HY510N - PC POWER SUPPLY SUPERVISOR (HawYang)
  • HY5110A - N-Channel Enhancement Mode MOSFET (HUAYI)
Other Datasheets by hytek
  • HY5100 - 2 Input / 3 Output Digital Delay Line

Full PDF Text Transcription

Click to expand full text
HY5640 TEC Controller Subminiature Controller for Thermoelectric Coolers The HY5640 is a subminiature temperature controller for thermoelectric coolers (TEC). This device is intended for “heat or cool” fixed temperature applications where front panel controls and digital readouts are not required. The HY5640 uses a thermistor bridge to precisely measure and regulate the temperature of a device affixed to a TEC. With proper heat sinking, the power stage of this device will deliver up to +/- 2 Amperes of current to a TEC. This controller was designed for single power suppply operation down to +5V. In addition, the device can be operated with dual supplies where VS can be as low as +3V and VDD as low as +5V.
Published: |