Datasheet4U Logo Datasheet4U.com

74HC253-Q100 - Dual 4-input multiplexer

Description

The 74HC253-Q100; 74HCT253-Q100 is a dual 4-bit multiplexer, each with four binary inputs (nI0 to nI3), an output enable input (nOE) and shared select inputs (S0 and S1).

One of the four binary inputs is selected by the select inputs and routed to the output nY.

Features

  • Automotive product qualification in accordance with AEC-Q100 (Grade 1).
  • Specified from -40 °C to +85 °C and from -40 °C to +125 °C.
  • Non-inverting data path.
  • 3-state outputs interface directly with system bus.
  • Common select inputs.
  • Separate output enable inputs.
  • Wide supply voltage range from 2.0 V to 6.0 V.
  • Input levels:.
  • For 74HC253-Q100: CMOS level.
  • For 74HCT253-Q100: TTL level.
  • CMOS low power d.

📥 Download Datasheet

📁 Similar Datasheet

  • 74HC253 - Dual 4-input multiplexer (Philips)
  • 74HC251 - Data Selectors/Multiplexers (Texas Instruments)
  • 74HC251 - 8-input multiplexer (Philips)
  • 74HC257 - Quad 2-Input Data Selector/Multiplexer (Motorola)
  • 74HC257 - Quad. 2-to-1-line Data Selectors/Multiplexers (Hitachi)
  • 74HC257 - Quad 2-input multiplexer (Philips)
  • 74HC257 - High-Speed CMOS Logic Quad 2-Input Multiplexer (Texas Instruments)
  • 74HC258 - Quad 2-input multiplexer (Philips)
  • 74HC259 - 8-Bit Addressable Latches (Texas Instruments)
  • 74HC259D - 8-Bit Addressable Latch (Toshiba)
Other Datasheets by nexperia

Full PDF Text Transcription

Click to expand full text
74HC253-Q100; 74HCT253-Q100 Dual 4-input multiplexer; 3-state Rev. 4 — 27 September 2022 Product data sheet 1. General description The 74HC253-Q100; 74HCT253-Q100 is a dual 4-bit multiplexer, each with four binary inputs (nI0 to nI3), an output enable input (nOE) and shared select inputs (S0 and S1). One of the four binary inputs is selected by the select inputs and routed to the output nY. A HIGH on nOE causes the outputs to assume a high-impedance OFF-state. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC. This product has been qualified to the Automotive Electronics Council (AEC) standard Q100 (Grade 1) and is suitable for use in automotive applications. 2.
Published: |