Datasheet4U Logo Datasheet4U.com

74LVC162373A - 16-bit D-type transparent latch

Description

The 74LVC162373A and 74LVCH162373A are 16-bit D-type transparent latches with 30 Ω termination resistors and 3-state outputs.

The 74LVCH162373A has separate D-type inputs with bus hold for each latch.

Both devices can be used as two 8-bit transparent latches or a single 16bit transparent latch.

Features

  • Overvoltage tolerant inputs to 5.5 V.
  • Wide supply voltage range from 1.2 V to 3.6 V.
  • CMOS low power consumption.
  • Multibyte flow-through standard pinout architecture.
  • Multiple low inductance supply pins for minimum noise and ground bounce.
  • Direct interface with TTL levels.
  • All data inputs have bus hold (74LVCH162373A only).
  • IOFF circuitry provides partial Power-down mode operation.
  • Complies with JEDEC standard:.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
74LVC162373A 16-bit D-type transparent latch Philips
74LVC162374A 16-bit edge triggered D-type flip-flop Philips
74LVC162245A 16-bit transceiver Philips
74LVC16240A 16-bit buffer/line driver Philips
74LVC16244A 16-bit buffer/line driver NXP Semiconductors

Other Datasheets by nexperia

Part Number Description
74LVC162244A 16-bit buffer/line driver
74LVC162245A 16-bit transceiver
74LVC162245A-Q100 16-bit transceiver
74LVC162245ADGG 16-bit transceiver
74LVC162245ADGV 16-bit transceiver

Full PDF Text Transcription

Click to expand full text
74LVC162373A; 74LVCH162373A 16-bit D-type transparent latch; 30 Ω series termination resistors; 5 V tolerant inputs/outputs; 3-state Rev. 6 — 16 September 2021 Product data sheet 1. General description The 74LVC162373A and 74LVCH162373A are 16-bit D-type transparent latches with 30 Ω termination resistors and 3-state outputs. The 74LVCH162373A has separate D-type inputs with bus hold for each latch. Both devices can be used as two 8-bit transparent latches or a single 16bit transparent latch. Both devices feature two latch enables (1LE and 2LE) and two output enables (1OE and 2OE), each controlling 8-bits. When nLE is HIGH, data at the inputs enter the latches. In this condition the latches are transparent, a latch output will change each time its corresponding D-input changes.
Published: |