ADF4150HV Datasheet | Analog Devices

FEATURES Fractional-N synthesizer and integer-N synthesizer High voltage charge pump: VP = 6 V to 30 V Tuning range: 1.0 V to 29 V (or ±1 V from VP supply rails) RF bandwidth to 3.0 GHz Programmable divide-by-1/-2/-4/-8/-16 outputs Synthesizer power supply: 3.0 V to 3.6 V Programmable dual-modulus prescaler of 4/5 or 8/9 Programmable output power level Programmable charge pump currents RF output mute function 3-wire serial interface Analog and digital lock detect GENERAL DESCRIPTION The ADF4150HV is a 3.0 GHz, fractional-N or integer-N frequency synthesizer with an integrated high voltage charge pump. The synthesizer can be used to drive external wideband VCOs directly, eliminating the need for operational amplifiers to achieve higher tuning voltages. This simplifies design and reduces cost while improving phase noise, in contrast to active filter topologies, which tend to degrade phase noise pared to passive filter topologies. The VCO frequency can be divided by 1, 2, 4, 8, or 16 to allow the user to generate RF output frequencies as low as 31.25 MHz. For applications that require isolation, the RF output stage can be muted. The mute function is both pin- and software-controllable. A simple 3-wire interface controls all on-chip registers. The charge pump operates from a power supply ranging from 6 V to 30 V, whereas the rest of the device operates from 3.0 V to 3.6 V. The ADF4150HV can be powered down when not in use. APPLICATIONS Wireless infrastructure Microwave point-to-point/point-to-multipoint radios VSAT radios Test equipment Private land mobile radios FUNCTIONAL BLOCK DIAGRAM SDVDD AVDD DVDD VP RSET REFIN ×2 DOUBLER 10-BIT R COUNTER ÷2 DIVIDER LOCK DETECT MULTIPLEXER MUXOUT LD CLK DATA LE DATA REGISTER FUNCTION LATCH PHASE PARATOR HIGH VOLTAGE CHARGE PUMP BOOST MODE CPOUT CURRENT SETTING DIVIDE-BY-1/ -2/-4/-8/-16 INTEGER VALUE FRACTION VALUE MODULUS VALUE OUTPUT STAGE RFOUT+ RFOUT- PDBRF THIRD-ORDER FRACTIONAL INTERPOLATOR MULTIPLEXER...