IS25LP128F
Overview
- Industry Standard Serial Interface - IS25LP128F: 128Mbit/16Mbyte - IS25WP128F: 128Mbit/16Mbyte - 3 or 4 Byte Addressing Mode - Supports Standard SPI, Fast, Dual, Dual I/O, Quad, Quad I/O, SPI DTR, Dual I/O DTR, Quad I/O DTR, and QPI - Software & Hardware Reset - Supports Serial Flash Discoverable Parameters (SFDP)
- High Performance Serial Flash (SPI) - 80MHz Normal Read - Up to166Mhz Fast Read - Up to 80MHz DTR (Dual Transfer Rate) - Equivalent Throughput of 664 Mb/s - Selectable Dummy Cycles - Configurable Drive Strength - Supports SPI Modes 0 and 3 - More than 100,000 Erase/Program Cycles - More than 20-year Data Retention
- Flexible & Efficient Memory Architecture - Chip Erase with Uniform Sector/Block Erase (4/32/64 Kbyte) - Program 1 to 256 Byte per Page - Program/Erase Suspend & Resume
- Efficient Read and Program modes - Low Instruction Overhead Operations - Continuous Read 8/16/32/64 Byte Burst Wrap - Selectable Burst Length - QPI for Reduced Instruction Overhead - AutoBoot Operation
- Low Power with Wide Temp. Ranges - Single Voltage Supply IS25LP: 2.30V to 3.60V IS25WP: 1.65V to 1.95V - 10 mA Active Read Current - 8 µA Standby Current - 1 µA Deep Power Down - Temp Grades: Extended: -40°C to +105°C Auto Grade (A3) : -40°C to +125°C
- Advanced Security Protection - Software and Hardware Write Protection - Advanced Sector/Block Protection - Top/Bottom Block Protection - Power Supply Lock Protection - 4x256 Byte Dedicated Security Area with OTP User-lockable Bits - 128 bit Unique ID for Each Device (Call Factory)
- Industry Standard Pin-out & Packages - M =16-pin SOIC 300mil - B = 8-pin SOIC 208mil - K = 8-contact WSON 6x5mm - L = 8-contact WSON 8x6mm - G = 24-ball TFBGA (4x6 ball array) - H = 24-ball TFBGA (5x5
