DNT90CA Datasheet - RF Monolithics

DNT90CA (DNT90CA/PA) 900 MHz Frequency Hopping Spread Spectrum Transceiver

Pin 1 Name GND ACT (DIAG_TX) I/O O (O) Description Power supply and signal ground. Connect to the host circuit board ground. This pin’s default configuration is data activity output. On a base, this signal blinks when a valid packet is received. On a remote, this signal blinks when a packet is tran.

- 900 MHz Frequency Hopping Spread Spectrum Transceiver - Point-to-point, Point-to-multipoint, Peer-to-peer and Store & Forward Capabilities - Transmitter Power Configurable to 40 or 158 mW - Built-in 0 dBi Chip Antenna - 100 kbps RF Data Rate - 128-Bit AES Encryption - Separate Serial Port for Diagnostics - Analog and Digital I/O for Sensor Applications - FCC and Canadian IC Certified for Unlicensed Operation The DNT90CA/PA FHSS transceiver modules provides a low-cost, versatile solution for wi.

DNT90CA_RFMonolithics.pdf