Datasheet4U Logo Datasheet4U.com

AP4202 - LED Driver

General Description

The AP4202 is a 9 channel LED Driver that supports 2 types of serial interfaces (SCI serial interface or serial F/F cascade interface) to program LED lighting.

Key Features

  • Power Supply Voltage 8.0V~24.0V 4.5V~5.5V (connect VIN pin and VDC1 pin).
  • Oprating Temperature 0 ~ 70°C.
  • Absolute Maximum Voltage 30V (VIN, LEDR0~2, LEDG0~2, LEDB0~2).
  • 2 Types of Serial Interface for Setting Lighting Data - 4-wire SCI interface (maximum communication clock: 5MHz) - Serial-F/F cascade (maximum communication clock: 10MHz) - Applicable to both 3.3V and 5.0V input signal (output is fixed to 5.0V).
  • LED Current maximum 100mA/ch - Constant Current Output 50mA/.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AP420N03SLG5 30V N-Channel Enhancement Mode MOSFET APM
AP4224GM N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics
AP4224M N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics
AP4226AGM N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics
AP4226D N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics

Other Datasheets by AKM (Asahi Kasei Microdevices)

Part Number Description
AP4201 LED Driver
AP4203 LED Driver
AP4405AEN Ultra-Low Power Voltage Detector
AP4410BEC Ultra Low Power Dual Voltage Detector
AP4460 Step-up DC-DC Converter

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
[AP4202] AP4202 9ch 100mA LED Driver IC 1. General Description The AP4202 is a 9 channel LED Driver that supports 2 types of serial interfaces (SCI serial interface or serial F/F cascade interface) to program LED lighting. The built-in 100mA drivable power MOSFET is used to shut off the LED current, and LEDs are controlled by a PWM method in accordance with the LED gradation data that is programmed into the device. Constant current output and Open drain output are selectable by DRSET setting pin. To reduce wirings in the system, voltage on anode side of LEDs can be communized. A maximum of 32 devices can be connected on a single BUS to a common master device; furthermore, each AP4202 retains its own programmed commands allowing continuous autonomous lighting.