Q1T-00600-311 Datasheet | AMETEK

1-8 TIME DELAY RELAYS Delay On Make (Series Load) Q1T Series Features - - - - - - - - 100% functionally tested Solid state digital timing 20:1 maximum to minimum timing ratio pact size Low cost Superior transient protection Epoxy encapsulated Flame-retardant and solvent-resistant polyester thermoplastic housing - Trimpot on-board with sealed cermet element - File #E65038 Operating Logic: Upon application of input voltage, the time delay starts. At the end of the time delay, the load is energized. Reset is acplished by removing input voltage. Note: The load may be located on either side of the line SPECIFICATIONS TIME DELAY Adjustment: On-board Trimpot Range: 50 ms to 10 hours in 9 ranges Repeatability: ±.5% +8 ms max. (0.25% typical) at constant temperature Accuracy: Maximum time -0%, +10%; Minimum time -30%, +0% INPUT Operating Voltage: 12, 24, 120, 240 VAC/DC ±10% (on DC models, unfiltered supply voltage must be full-wave rectified) Frequency: 50/60 Hz OUTPUT Type: Solid state normally open series load Rating: Maximum current -1 A AC/DC (resistive or inductive) Life: 100,000,000 operations PROTECTION Transient Voltage: Metal oxide varistor (see ratings below) Dielectric Breakdown: 3000 VAC, RMS, terminals to mounting Isolation Resistance: 100 megohms min. between terminals and case MECHANICAL Termination: .25” x .032” male fast-on terminals Mounting: Surface mount with one #8 screw ENVIRONMENTAL Storage Temperature: -40°C to 85°C Operating Temperature: -40°C to 65°C Humidity: 95% relative .25 X .032 MALE FAST-ON TERMINALS (4 PL.) .88 1.25 TIME DELAY ADJUSTMENT ACCESS 2.00 SQ. LOGIC FUNCTION DIAGRAM Input Voltage On Off On Off Timing Load Delay On Make Function C L 1 C L 3 .170 DIA. ORDERING INFORMATION TIME RANGE .05 to 1 sec. .25 to 5 sec. .5 to...