AMIS-52000 Datasheet PDF - AMI SEMICONDUCTOR Single-Chip Radio Transceiver Specs

AMIS-52000 - Single-Chip Radio Transceiver

Datasheet Summary

Description

RX1 and RX2 are RF antenna inputs to the AMIS-52000.

The internal design of these circuits is identical.

Each internal circuit can be trimmed to compensate for device process tolerances and external component tolerances.

Features

Very low power single-chip transceiver.
Minimal external components.
Low power RC oscillator.
Unique Quick Start, low-noise oscillator (patent pending).
Extreme low power RF Sniff Mode™, wake on RSSI.
Internal trim functions.
I2C control interface.
Serial TX/RX data port.
Clock generation for an external microprocessor.
Wake up on RSSI.
Unique antenna diversity dual receiver (patent pending).

Datasheet Details

Part number	AMIS-52000
Manufacturer	AMI SEMICONDUCTOR
File Size	681.12 KB
Description	Single-Chip Radio Transceiver
Datasheet	AMIS-52000 Datasheet
Additional preview pages of the AMIS-52000 datasheet.

📁 Similar Datasheet

AMIS-52150 - Low-power Transceiver Device (ON Semiconductor)

AMIS-14935 - Audio Amplifier (AMIS)

AMIS-30421 - Micro-Stepping Stepper Motor Bridge Controller (ON Semiconductor)

AMIS-30511 - Micro-Stepping Motor Driver (ON Semiconductor)

AMIS-30512 - Micro-Stepping Motor Driver (ON Semiconductor)

AMIS-30521 - Micro-Stepping Motor Driver (ON Semiconductor)

AMIS-30522 - Micro-Stepping Motor Driver (ON Semiconductor)

AMIS-30523 - CAN Micro-Stepping Motor Driver (ON Semiconductor)

AMIS-30532 - Micro-Stepping Motor Driver (ON Semiconductor)

AMIS-30542 - Micro-Stepping Motor Driver (ON Semiconductor)

Full PDF Text Transcription

Click to expand full text

AMIS-52000 Single-Chip Radio Transceiver 1.0 Introduction The AMIS-52000 is a low cost, ultra low power ASK/OOK (Amplitude Shift Keying/On-Off Shift Keying) transceiver intended for narrow band RF applications. The device is targeted for applications at 433MHz but can operate from 260 to 700MHz. The adjustable RF output ranges from –26 to +6dBm into a matched 50ohm load. The receiver contains two independent receive channels which can be Data Sheet connected to separate antennas for antenna diversity applications. On chip trim registers eliminate manual trimming of external components. Using the on chip trimming, transmit and receive frequencies achieve 5ppm accuracy over the entire voltage and temperature range. 2.

Published: Nov 4, 2009 |